Question about 2002 kawasaki KMX 125

1 Answer

Keihen carb Does keihen carb work on kmx 125 its of a cr 125 97 model?

Posted by on

  • Anonymous Mar 17, 2014

    how to repair kmx 125 mono shock absorber

  • Anonymous Mar 26, 2014

    hi i just had my first kmx 200 but a 125engine...i need to know how to remove the seat. 1988 kmx 125. f reg the model i slected is wrong but mine is not in there



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 2,336 Answers

Honda or husquy cr 125

Posted on Nov 10, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hi there I have a kmx 125 with a 200cc head, barrel and piston just wondering what the difference between a kmx 125cc carb and a 200cc carb

This venturi (throat) size and the jet size are different...the smaller carb will give more bottom end.... the larger carb will make it run better mid range and top end...

BOTH must be jetted someone that knows how!!

Aug 29, 2017 | Motorcycles

1 Answer

Kmx 125

You need to clarify the problem, unsure what you mean by changing the mix.

Jun 07, 2013 | Motorcycles

1 Answer

Do you have any ideas how to adjust supply of 2t oil that cause too much smoke and oil coming out from exhaust pipe?a newly overhaul kmx 125, 2002 model .

You adjust the oil via the oil pump. The throttle cable splits, one section goes to the carb and the other to the pump, you adjust the play/tension of the wire on the pump, while pulling back the throttle to see if it's aligning properly at full throttle and idle. Two strokes tend to be very smokey so unless the smokes an unusual colour it's usually not a problem. I have a Kmx 125 with a 200cc engine, I prefer running slighty rich on oil, better than running slightly lean! :)

Aug 12, 2011 | 2002 kawasaki KMX 125

1 Answer

Kmx 125 fully ported modified for MX racing consumes too much gas,what will i do to restore it back to normal consumption,want to use it daily...thanks a lot...

Install a new cylinder and re-jet the carb back to stock. If the ported cylinder has been bored you will need new piston and rings also. I would re-jet the carb first and see if that change will suffice in the fuel economy area. Changing out the cylinder etc., is costly. Check the front and rear sprockets. If they are not the stock sprockets, ( 14 tooth and 48 tooth ), replace with stock. Please rate my answer.

Aug 27, 2010 | 2000 kawasaki KMX 125

1 Answer

Kmx 125

on carb is a screw the idle screw turn this in 1/4 of a turn with the bike running at a time till it runs at 1000 rpm or 1200rpm db9967d.jpg

Sep 27, 2009 | 2002 kawasaki KMX 125

2 Answers

1988 Kmx 125`hits short flatspot /stutter at 8000 revs

You changed the back pressure in the exhaust and that is what causing your problem either put the washer back in or have the carb properly jetted

Aug 27, 2009 | 2001 kawasaki KMX 125

2 Answers

Carbureter is leaking fuol an boggin out

hi urfkel,

keep the carb tight but breathable.
change the gasket and the replace the tubes. KMX oem carbs are pretty good, just have to take care of it with the right tuning and perioding cleaning.



Jul 15, 2009 | 2002 kawasaki KMX 125

1 Answer


need to move the mixture screw in out think about 2 1/2. turns should start u off

Jun 06, 2009 | 2001 kawasaki KMX 125

1 Answer

I went on my kmx 125 earlyer and the petrol pipe has come off and i dont know wherte to put it back on...when i switch petrol pipe on it petrol is spilling on the floor any ideas thanks.

The petrol line from the gas valve runs to a brass fitting on the side of the carb just above the large bottom bowl.

Please rate this answer. Thanks JJ!

Apr 23, 2009 | 2000 kawasaki KMX 125

2 Answers

Kawasaki KMX 125 losing power

hi man,
I had a similar problem, so maybe I can help you. it can be connected with air filter. under your seat there should be some kind of cover on the air filter. just remove it. I've noticed this problem when I unrestricted my KMX 125. the hole on the cover on the air filter is too small.

Apr 04, 2009 | 2001 kawasaki KMX 125

Not finding what you are looking for?
2002 kawasaki KMX 125 Logo

Related Topics:

315 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 3 Expert

77194 Answers


Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides