Question about 2007 Victory Vegas

1 Answer

Vegas led lighting

I have a vegas and wondering if anyone have used LED light? I just want to see some sample how the light should install so it shine the bide from front to back. Please direct me some sample pic if you can...thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,336 Answers

I dont have any pictures of my bike at night but the ones I have look great. There called Boogey Lights and they look awsome. There not just a pod like most of them are, there actually strips of light that mount anywhere on the bike and cannot be seen when there off. The pod lights look terrible because they stick out like a sore thumb. I have strips of lights under the tank, the ignition cover and on the frame rails under the bike to shine on the ground. go to www.boogey.com

Posted on Nov 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

All of my turn signals flash simultaneously


Hi, Kevin try holding both turn signal switches/buttons in at the same time if that doesn't work replace your turn signal module/flasher for more information about your question and valuable "FREE" downloads that you will need please click on the websites below. Good luck and have a nice day.
Switching to LED turn signals
LED turn signals How to
Turn Signal Issue after troubleshooting
http://www.granitestatechapter.com/mydata/05-06%20Hammer_06%20Jackpot_Service_Manual.pdf

Jul 19, 2015 | 2006 Victory Vegas

1 Answer

I bought a harley accessory switch for my led lights. I installed switch and only half led lights light up. What do I need to make led lights work with switch thank you


If the lights are not blown, only two things you need to make them work, ground and power. If a wire is broken or not connected properly then they won't work.

Jul 22, 2014 | Motorcycles

2 Answers

I have a 1999 kawasaki zx7r ninja i installed led front turn signals and the only way they will work is if i rev the engine can anyone help


When you rev the engine, the alternator voltage increases. I think that the LED bulb does not light up, do to not enough voltage at lower rpm's or idle speed. Buy some LED bulbs that are rated for the correct voltage. There is a minimum voltage requirement before the LED can turn on. If you have the correct voltage LED bulbs, then there is not enough current, in hundreds of milliamperes, until you rev the engine.

Jun 07, 2014 | kawasaki Motorcycles

1 Answer

My 1992 yamaha virago 750 quit firing were should i start to solve this promblem


First and foremost, check your "Stator" I have an 89' XV750 and had to deal with the same issue. I put a light kit on the bike not thinking anything about power drain. Then my stator went out. After I replaced my stator, it was fine after I installed some LED volt limiters(resisters) witch are very easy to install.

Mar 16, 2013 | 1988 Yamaha XV 535 Virago DX

2 Answers

Installed new led taillight and now there is no brake light/blowi


I fixed it. The LED light needs a "load equalizer" to operate properly. Instructions said nothing of needing one. I combed the internet and found the answer. I responded to FixYa by e-mail "REPLY" and informed of the fix. Thanks for your help...I'll remember your site for future needs.

Mar 19, 2009 | 2004 Harley Davidson FLSTF - FLSTFI Fat...

2 Answers

Installing led 2 wire lights


I had the same problem with my 1997 marauder the only way i have found to make them work is to hook up the LED signal lights into the stock signal lights i know it sounds crazy but what i have figured out is that it uses the stock bulbs like a fuse. all you have to do is take the headlight out just like you did when you wired in the LED lights and wire in your stock bulbs along with the LED lights once you have done this put the stock bulbs in the headlight assembly and put the headlight back in this should fix your problem at least it worked for me let me know if it works for you as well good luck

Mar 12, 2009 | 1999 Suzuki VZ 800 Marauder

2 Answers

Honda magna tail light not functioning properly


Did you just replace the bulb with the LED? If so, you probably got the wrong bulb. Make sure it is a 2 circuit bulb like an 1157 dual filament.

Mar 05, 2009 | 1994 Honda VF 750 C Magna

Not finding what you are looking for?
2007 Victory Vegas Logo

Related Topics:

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Victory Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4481 Answers

Kirk Augustin
Kirk Augustin

Level 3 Expert

2019 Answers

Are you a Victory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...