Question about 2002 Moto Guzzi V11 Sport Rosso Mandello

1 Answer

Exhaust Hello All

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,336 Answers

Does anyone on this site have installed a Moto Guzzi factory Ti Exhaust system that also came with the ECU and new hangers?? Is this a full system from the heads or is it just the cans??? How well does it work?? Is there any other suggestions for race / performance exhuast system?? I see many members use the Stucci or Mistral X-over and what ever cans the like. If I go this road is there any header pipes that can or should be used to work with the X-overs?? Any other Exhaust system (race or otherwise) suggestions would be greatly appreciated. I have a 2004 V11 without the O2 sensor.I don't have any experience with the MG Ti set up but I do have alot of mod's in line with what you're considering. There are some with the set up you are considering and they will be here soon, no doubt. This is a great and helpful group/site.The biggest issue with the actual exhaust headers isn't so much which cross over will work, but that the '04's have that first cross over, in front of the alternator cover. The earlier bikes did not have this, and was added after'02(?) to address a percieved dip in the power curve at about 4000 rpm. This front cross over tends to loosen and then it is free to rattle around, and creates a exhaust leak. I am about to try solving this on mine as soon as I get the new gaskets. You could also look at Guzzitech.com to find headers made with no front cross over at all. There are several popular aftermarket cross overs for the one under the motor, and several threads concerning them. Some are said to improve either your mid range or top end power. Some prefer the Mistral, I think, because it allows the addition of an aftermarket center stand. There are many opinions, but there is also a central theme about them all. You will almost assuredly need some type of fuel control system, or a ECU remapping. The PowerCommander III seems to be the weapon of choice. I bought my bike already mod'ed, including the PC III, so I have never experienced the power dip many discuss here. Done properly, you will not be disappointed. After all, who amongst us has ever said,It's got more power, I don't like it now Spend enough time here in search mode and you will find many questions answered, and in some cases more questions now than when you first started... laugh.gif Good luck in your quest for POWER,,,

Posted on Nov 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Exhaust leaking oil from manifold


no you got a big problem you get to fix it

Dec 17, 2013 | 2003 Aprilia Tuono 125

1 Answer

Hello I have a 2004 Honda VTX 1300C, my motorcycle is popping and crackling. When I roll on the throttle it starts popping more and acts like it wants to die, when I decelerate it pops and backfires. I had...


you might consider the fuel mixture being too rich and that excess gas is getting into the exhaust and exploding there; it could also be that the exhaust valves in your engine are not closing all the way and excess gas is pouring into the exhaust, last is timing...if it is off, the exhaust valve will be off cycle too and might do the same thing...Check it out!

Jan 23, 2013 | Motorcycles

1 Answer

I just got a 2006 kawasaki zx6r 636 and the red fi lite is on, but the bike has a power commander on it, is that what is causing the lite to come on? Help please!


Hello what you need to do is take your exhaust servo off your bike then buy an exhaust servo eliminator which you can buy from ebay, i had same problem and it works fine now with no f1 light coming on.

Dec 04, 2012 | Motorcycles

1 Answer

Hello, I'm installing new Thunderheader 2 - 1 exhaust pipes on my 2001 Fatboy. I need to know the torque specs on the bolts. Thanks!


Nuts (cylinder studs) - 60-80 inch pounds.
Nuts exhaust support tubes to frame - 19 foot pounds
Muffler support nuts - 19 foot pounds

Keep in mind that these torque values are for original stock equipment and may not be correct for your aftermarket parts applications. Use you common sense when installing the exhaust system. If a bolt looks and acts like it won't withstand the torque, don't try to apply it. People have been working on Harleys for years without the benefit of a torque wrench. It's not rocket science.

Good Luck
Steve

Aug 05, 2011 | 2001 Harley Davidson FLSTF - FLSTFI Fat...

1 Answer

Power seems to run out early running through the gears and there is a hollow sound in the exhaust at the end


Hello...from your comment it sounds like your bike needs a valve adjustment. The "hollow" sound in the exhaust and the powerband loss is usually a good indication of this. Have you had them adjusted lately? This first adjustment should be done at 5000 miles and then every 7500 miles there after.
The settings are:
Intake .003 - .005
Exhaust .007 - .009
Always set valves on a COLD engine.

I hope this helps...good luck with your bike.

Jul 14, 2011 | 2006 Suzuki Boulevard C50T

1 Answer

If I do full headers and exhaust on my 08 Suzuki gsxr 600, do I need to do additional upgrades


Hello,

Yes, your carbs will have to be tuned to your exhaust - this, usually, means upgrading the needles/seats in your carbs. I bought a Cobra exhaust system for my Suzuki (earlier model) and it came with the upgrade kit for my carbs.

Some people are happy adjusting the jets out further and living with poor fuel mileage, fouling plugs and lousy performance.

Do some research by calling your parts dealer and ask them if they have the carb kit for the exhaust you are wanting to buy. I use one of two online dealers; Bike Bandit or Old Bike Barn

Hope this helps. If you find this information useful, please vote on this post. Thank you.

Regards,

Oz

Jan 23, 2011 | 2008 Suzuki GSX-R 600

1 Answer

How do I remove arrow 2 into1 exhaust system


hello if u want to sell your old exhaust system please email me at
ezmoneybruce@yahoo.com
thank you

Dec 26, 2010 | 2008 Triumph Triumph Bonneville

1 Answer

Hello I'm desperqately looking for an exhaust for the suzuki GS750 - year 1977 (France) fro my husband (4 in 2 ) GSM company could provide such exhausts, but is closing (the company) Suzuki France don't...


Try here: www.exactrep.co.uk
They will post to France. The orginal system is no longer available new. If your husband still has the down pipes you can just buy the silencers.
There is a second hand system on ebay that is genuine Suzuki, item number:330476261465

Sep 28, 2010 | Suzuki GS 750 Motorcycles

1 Answer

Hello my bike is not starting very well, always


you might find one of two things,the carbureetors need cleaning out and rebalancing and is quite likely that the points are out of adjustment,the points on this model and most of the xs650 were critical in getteing right,i think you have a combination of a couple of small problems but get these two things sorted out and the bike should go a lot better

Jun 27, 2009 | 1978 Yamaha XS 650 SE

1 Answer

Exhausts


I know this may sound rather stupid but my father has bought a brand new bike and he only intend to use it on our farm. Now the trouble is that neighbours complaint about the noise from the bike and we have asked the dealer if it was possible to get a more quieter exhaust, but he just said that you only were able to get exhausts that increase noise. So what we need is a exhaust which is less noisy (The standard one is direct flow, or what you call it) and one that doesn't sacrifice too much of the power. You can hear it miles away I love it, but my father tells me to only put a maximum of half throttle when I ride it, which is a little boring Can you help me ? , As for a quieter exhaust for your bike, your dealer wasn't very knowledgeable on the subject. While most aftermarket exhausts do increase noise, there are some to help decrease as well, without saraficing power. I can think of a couple over here in the US, but I'm not sure if you get many distributors for our stuff over there. There's also a European exhaust manufacturer that comes to mind, which is Leo Vince. And four-stroke exhausts aren't exactly cheap. Some ones that you could look into are: -FMF Powercore IV Q2 (around 96db) *slip-on* -Pro Circuit Type 496 (I'm not sure around what db level this is, but I know that the body is longer and it uses a special packing to help reduce noise) *slip-on* -Leo Vince X3 (every leo vince exhaust includes inserts for 99 and 96db, and also a spark arrestor) *full exhaust*,,,

Nov 10, 2008 | 2008 HM CRE F250XI

Not finding what you are looking for?
2002 Moto Guzzi V11 Sport Rosso Mandello Logo

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Moto Guzzi Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4477 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

Are you a Moto Guzzi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...