Question about 2002 Moto Guzzi V 11 Le Mans

1 Answer

Exhaust Hello All

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 2,336 Answers

Does anyone on this site have installed a Moto Guzzi factory Ti Exhaust system that also came with the ECU and new hangers?? Is this a full system from the heads or is it just the cans??? How well does it work?? Is there any other suggestions for race / performance exhuast system?? I see many members use the Stucci or Mistral X-over and what ever cans the like. If I go this road is there any header pipes that can or should be used to work with the X-overs?? Any other Exhaust system (race or otherwise) suggestions would be greatly appreciated. I have a 2004 V11 without the O2 sensor.I don't have any experience with the MG Ti set up but I do have alot of mod's in line with what you're considering. There are some with the set up you are considering and they will be here soon, no doubt. This is a great and helpful group/site.The biggest issue with the actual exhaust headers isn't so much which cross over will work, but that the '04's have that first cross over, in front of the alternator cover. The earlier bikes did not have this, and was added after'02(?) to address a percieved dip in the power curve at about 4000 rpm. This front cross over tends to loosen and then it is free to rattle around, and creates a exhaust leak. I am about to try solving this on mine as soon as I get the new gaskets. You could also look at to find headers made with no front cross over at all. There are several popular aftermarket cross overs for the one under the motor, and several threads concerning them. Some are said to improve either your mid range or top end power. Some prefer the Mistral, I think, because it allows the addition of an aftermarket center stand. There are many opinions, but there is also a central theme about them all. You will almost assuredly need some type of fuel control system, or a ECU remapping. The PowerCommander III seems to be the weapon of choice. I bought my bike already mod'ed, including the PC III, so I have never experienced the power dip many discuss here. Done properly, you will not be disappointed. After all, who amongst us has ever said,It's got more power, I don't like it now Spend enough time here in search mode and you will find many questions answered, and in some cases more questions now than when you first started... laugh.gif Good luck in your quest for POWER,,,

Posted on Nov 10, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hello, i have a dryer t3290 frigilux and is showing an error E8 in its screen , i dont know what could be? Do you have any ideas what could be?

This is usually a restricted exhaust warning. make sure exhaust is clear fom dryer to outside. Also try removing exhaust from dryer and running without and see if code comes back.

Dec 29, 2016 | Dryers

2 Answers

Why wont my 2007 aveo will not go faster than 20 mph

Fuel limitation. From tank to carb/injectors are you getting enough fuel supply? also Do you have a clogged air filter? Restricted exhaust system. To test exhaust system, unbolt the exhaust pipes from the manifold and see if it is restricting exhaust. If car runs better it needs exhaust work. All of above is if car runs good under 20 mph, Check fuel filter first, to see if its getting enough of fuel. Good-Day!

Aug 24, 2014 | 2007 Chevrolet Aveo Sedan

1 Answer

Blowing flames

Hello Carleton, Fire out of the exhaust port with no pipe is normal. You want to bring the piston to top dead center on the compression stroke. Both valves should be fully closed.

Mar 24, 2014 | Craftsman 42 in. Deck 19.5hp Lawn Tractor

1 Answer

Hi my dryer wont dry 100% the model # mytag MDG10CSAAW

hello caran.... the problem is most likely lint in the exhaust hose. pull the dryer out from the wall, remove the exhaust vent pipe and check it all out removing any lint you come across. also go out doors and clean the exhaust pipe and the vent cover. joe

May 23, 2011 | Maytag Dryers

1 Answer

Erroe code po405 on my car

The error code PO405 = EGR, ( Exhaust Gas Recirculation ), sensor A circuit low input.

What the EGR does;
EGR = Exhaust Gas Recirculation system
Recycles small amounts of exhaust gas from exhaust system, 8 to 10 %, and mixes it with intake manifold air going into the combustion chambers. The addition of this inert, or non-combustable exhaust gas limits the peak combustion temperatures to a range that is below 2,500 degrees F, where the formation of nitrogen oxide, ( NOx ), is known to occur.

Here's a picture of an EGR valve to help you locate yoursem1cl_1.jpg
You may find that you just have a lose hose, or you may have a small vacuum leak.

I hope this helps you.

Mar 09, 2011 | Ford Focus Cars & Trucks

1 Answer

Phillips Freevents 11NB5800

Hello sir, hi, try to check if the side exhaust fan is blowing out reasonable amount of hot air, if not you side exhaust fan is dirty, it may need cleaning, If the exhaust fan has reasonable amount of hot air blowing out, then you may need to buy laptop cooler, inquire about it at your laptop dealer.

Nov 07, 2009 | Computers & Internet

1 Answer

Hello, thermostate will not stay lit. vacation

Hello, if your going on vacation any way, just shut the power to it off at the breaker box and deal with it later.

Jul 07, 2009 | Fasco Bradford White Hot Water Heater...

1 Answer

Hello...I have an 09 elantra I just bought. It

The ticks and pings you hear is just the exhaust / header cooling down. Hot things expand and what your hearing is the exhaust system cooling down " contracting " . Dont worry about it, there's nothing you can do.

Jun 25, 2009 | 2008 Pontiac G5

1 Answer

How do you drop the starer away from the motor

Hello kiernan2002: My name is Roger and i will help you. There is no easy way to remove the starter. You will need to drop the exhaust down to gain the needed clearance to remove the starter. Try not to break the exhaust studs as you loosen the nuts. My experience is they will probably break. Make sure to replace the exhaust packing when you put the exhaust back up. otherwise they will leak. Please rate the answer you received. This is how we know you received need information. Thank You for using FixYa.Roger

Mar 14, 2009 | 1994 GMC Jimmy

1 Answer

Valve clearance

Hello, For all 615, 616 (4cyl) and 617 (5cyl) through 1985 model year is:
cold intake 0.10mm or .006in
exhaust 0.35mm or .014in
hot intake 0.15mm or .007in
exhaust 0.40mm or .016in
CYA, Gator241

Dec 16, 2008 | 1983 Mercedes-Benz 300-Class

Not finding what you are looking for?
2002 Moto Guzzi V 11 Le Mans Logo

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Moto Guzzi Experts


Level 3 Expert

77499 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 2 Expert

184 Answers

Are you a Moto Guzzi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides