Question about 2007 HM CRM F490X I

1 Answer

New pro I had my f490xi crm finally running and it seemed to be running solid. I went to start it up last night and it wouldn't start. I tried to start it a few times and I could smell gas and it makes a sound like it wants to start but it just won't. Any ideas?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 2,712 Answers

Probably battery

Posted on Nov 10, 2008

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Yamaha V star 650 skipping on the highway

I am not clear about what it is doing when you say skipping

Nov 23, 2014 | Yamaha Motorcycles

1 Answer

Ktm 85 2014 wont start seems to be flooding, just purchased yesterday and was fine, then last night it suddenly won't start, like its flooding? Any suggestions?

Could be. Did you turn the fuel valve off last night?
Try starting with no choke holding throttle open about half way..

Mar 30, 2014 | 2014 KTM SX 85

1 Answer

Backfiring and trouble starting

If you change the exhaust pipes, you have to sync the carbs (if you cant sync them, you have to change the carb jets), usually it is backfiring because the carbs are not in balance.

May 18, 2013 | 1996 Honda VT 600 C Shadow

1 Answer

I have a 2000 zx12 left to me from my family member passing away. the bike set for 6 years i replaced the fuel pump and gas tank the old tank still had old gas. the bike started and ran fine. one day i...

You should have the injectors cleaned, As fuel gets old, the most burnable part of it evaporates This leaves a very liquid gunk behind, the gunk contains some very big bits of rubbish, (compared to clean fuel or injectors) it sounds as though you have blocked injectors. If you give them a good clean and fill the tank with new fuel you should fix the problem.

Apr 14, 2012 | 2000 kawasaki ZX-12R

2 Answers

Have 2007 honda sabre 1100 that headlight went out on. High beam light also went out at same time. Just replaced headlight bulb. Then 1 day later start switch not working. Seems to have a short. When press...

I think your problem is in the starter button. It is a two position switch. Push it halfway and the head light goes out so more electricity goes to the starter. Push it in all the and the solenoid engages. The starter button is either dirty or broken. You can try cleaning it, but you may have to replace the switch assembly (the buttons are not sold separately).

Sep 07, 2010 | Honda VT 1100 C2 Shadow Sabre Motorcycles

2 Answers

Direct bikes scooter wont start

you need to have some fuel in the system over night as when it is shipped it is completly dry when this is done it should start with out any problems if it still has the same problem then you will need to charge the battrie

Nov 02, 2009 | 2004 Factory bike Chrono SM 250

1 Answer


First what kind of noise. Plus did you replace the cam chain tenisor when you replaced the chain. That will make a noise in the top end. Other than that piston slap will cause some noise but you will hear it more at higher rps most of the time. I have seen a lot of problems latly where the tank does not breathe properly so it will start spudder then die a few times. Usually it is the gas cap.,

Nov 10, 2008 | 2007 HM CRE F490X I

Not finding what you are looking for?
2007 HM CRM F490X I Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top HM Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4477 Answers


Level 3 Expert

61046 Answers

Angelo Stewart
Angelo Stewart

Level 2 Expert

224 Answers

Are you a HM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides