Question about 2007 HM CR 125R

1 Answer

Bike won't start.

Why a 1995 CR-125R won't start after adding fuel to an empty tank?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,712 Answers

Put your petrol tap onto prime

Posted on Nov 10, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Honda CR 125 R starts and runs then just stops


Hi, Anonymous and the usual suspects are:
1. Severely discharged or a damaged battery must have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
2. Faulty alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Faulty main circuit breaker or ignition switch, check for loose connections and continuity.
5. Faulty system and or ignition relay, check for continuity.
6. Faulty ignition coil, ignition/electronic module.
7. Faulty CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Faulty neutral, side stand or clutch lever safety switch.
10. Fuel tank empty
11. Fuel tank contaminated with ethanol sludge.
12. Water or dirt in the fuel system, or clogged filter.
13. Restricted, blocked or kinked fuel line.
14. Faulty fuel pump.
15. Faulty pressure regulator.
16. Faulty or clogged fuel injectors.
17. Lean angle switch is faulty or needs adjustment.
For more information about your issue and valuable "FREE" downloads that you need please click on the blue links below. Good luck and have a wonderful day.
03 CR125 starts then stops
Motor dies after running for 5 minutes or so
Honda CR 125R 2002 Sevice Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda Elsinore CR125M Owner Manual

Apr 25, 2014 | 2002 Honda CR 125 R

1 Answer

2002 Honda CR 125 R cuts out when hot


Hi, Bob and the usual suspects are:
1. Severely discharged or a damaged battery must have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
2. Faulty alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Faulty main circuit breaker or ignition switch, check for loose connections and continuity.
5. Faulty system and or ignition relay, check for continuity.
6. Faulty ignition coil, ignition/electronic module.
7. Faulty CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Faulty neutral, side stand or clutch lever safety switch.
10. Fuel tank empty
11. Fuel tank contaminated with ethanol sludge.
12. Water or dirt in the fuel system, or clogged filter.
13. Restricted, blocked or kinked fuel line.
14. Faulty fuel pump.
15. Faulty pressure regulator.
16. Faulty or clogged fuel injectors.
17. Lean angle switch is faulty or needs adjustment.
For more information about your issue and valuable "FREE" downloads that you need please click on the blue links below. Good luck and have a wonderful day.
cr 125 cutting out when full open throttal
CR125 FEW PROBLEMS WHATS MY CAUSE
Honda CR 125R 2002 Sevice Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda Elsinore CR125M Owner Manual

Aug 05, 2013 | 2002 Honda CR 125 R

1 Answer

2004 Honda CR 125 R will not start


Hi, Anonymous and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the enrichner.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead acid batteries.
14. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
15. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
16. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
17. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
18. Faulty neutral, clutch lever, or kickstand safety switch.
19. Faulty fuel pump or fuse or relay.
20. A stuck bent or burnt valve.
21. Tilt sensor needs a reset.
22. Security system not disarming alarm needs a reset.
23. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2003 cr125 won start
What to Do Check When Dirt Bike Won Start
Honda CR 125R 2002 Sevice Manual
http://www.partsfish.com/page/oem-parts-for-honda
Honda Elsinore CR125M Owner Manual

Jun 28, 2012 | 2004 Honda CR 125 R

1 Answer

My 2002 Cr 125r won't start. While riding it


change your sparkplug bus use a BR9SE sparkplug

Apr 20, 2012 | 2002 Honda CR 125 R

1 Answer

I have fuel in gas tank-after shutting off will not start unless I put gas into fuel tank. Is it a fuel filter issue. or?


Just a question. Do you run your car on empty. If so that could be your problem with an empty tank you are sucking all the dirt through the filter and making it plug up. It is better to keep your tank above half full and does not cost any more than to run on empty. All mechanics will tell you to always keep your tank above half full.

Nov 28, 2017 | 2001 Ford Expedition

3 Answers

My dirt bike fires up and only runs for like 20 seconds what is wrong with it


There could be a few things to look for when this happens. I found on my KLR 650 i had a bit of rust or dirt in the tank that had clogged my fuel line by the shut off. If the bike has been sitting, the fuel may have gone bad or started to "gel" in the bottom of your carb bowl causing the float to hang up or flood the bike out. Hope this helps.

Sep 15, 2009 | Cycling

2 Answers

Fuel problem


Are you pinching any hoses?

May 24, 2009 | 1995 kawasaki VN 800 A Vulcan

1 Answer

My cr 125r 97 modle stalled and wont start


If it has a new packing you could have done it different and it might need to be jetted

Apr 09, 2009 | 2002 Honda CR 250 R

1 Answer

I added a bit of bad fuel in the tank


Hi and welcome to FixYa,

Initially, try to drain the carbs themselves. Each carb has a drain screw at the bottom specifically for this purpose. Just turning these drain screws a couple of turns counter-clockwise would allow the fuel inside the bowl to drain out through a hose. Normally, I do it with the tank's fuel valve open (PRI) so as to enable the gas to flow freely, the fresh gas to wash the inside of the bowl and prevent the float from sticking in the open position. In some instances that the the tank's fuel valve open is closed when doing this, the carb has a bad habit of overflowing. Of course care and safety should be in mind as raw fuel would tend to be draining out.

Good luck and Thank you for using FixYa. Happy Holidays.

Dec 15, 2008 | 1995 Honda VFR 400 R NC30

1 Answer

Bike stall


what should I do?Check the fuel tank petcock position. Check that the valve is in the proper position for fuel to flow. It happens. It's possible that the spark plug is fouled. Remove the plug and inspect for evidence of fouling. Clean and replace and then try starting the engine.,

Nov 10, 2008 | 2007 HM CR 125R

Not finding what you are looking for?
2007 HM CR 125R Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top HM Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4818 Answers

yadayada
yadayada

Level 3 Expert

78919 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a HM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...