Question about 2006 CCM 404 Enduro

1 Answer

Oil changing How to change oil?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,712 Answers

1.remove the oil filler plug from the top of the frame between the fuel tank and headstock 8mm allen key. 2 remove the front drive sprocket cover (two 5mm allen screws) this exposes the cover plate for the oil filter. 3 remove the sump bash plate if you have one (DS models) its held on with four nuts and bolts (5mm allen/13mm a.f. nuts) yes its a bit awkward. 4.place an old drain oil can under the frame and remove the frame drain plug (13mm a/f) situated below the engine on the nearside frame rail be quick to move your drain can under the jet of oil that is shooting from the frame onto your knee oh yes have plenty of rags handy! 5, remove the magnetic drain plug from the sump again move your drain can under the oil pouring onto the floor. 6, remove the oil filter cover plate via the 3 5mm allen screws and catch more oil..... remove the old filter, give the housing a wipe out then push in the new filter .... refit the cover plate. 7, make sure you have re-fitted your frame and sump drain plugs..... even more oil on the floor is usually a good indicator you have forgotten one. 8,measure out 2 litres of oil and slowly fill the frame using a long flexible funnel don't rush it to avoid airlocks. 9, leaving the long funnel in place I turn the motor over a dozen times on the kickstarter (ignition off) to circulate the oil round the filter etc and remove any air (you will hear big glugging noises from the filler whilst hand turning the engine. 10, pour another 1/2 litre in, refit the filler cap important don't run the bike without the filler cap in place...more oil on the floor! run the bike for five minutes switch off check the oil level at the sight tube on the nearside of the headstock just below the filler, sight tube should be half full after you have turned the engine off...top up a bit at a time and repeat the running/sighting procedure. 11, now spend at least an hour cleaning the oil off the garage floor! top tip ..... put some plastic sheet down before you start! ,,,

Posted on Nov 10, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I want to know what is the optimum km range for changing engine oil in Honda Unicorn.


Optimum km range for changing oil in any bike should be 1000km or 6 months which ever comes first. The oil in a motor is designed not only for lubrication but also to keep the engine clean, if you leave oil in a motor for too long than you are lubricating your motor with dirty oil, oil also loses its viscosity to lubricate and that is why there is a time span. Both oil companies along with manufacturers have increased there oil change (servicing) intervals to some silly kilometre and time spams, sometimes common sense prevails. Use a good quality oil, no need to buy the top of the range and maintain your bike

Feb 19, 2011 | 2005 Honda Unicorn

2 Answers

I have a kawasaki ninja 250 when i chang the oil is it ok if i dont change the filter


Hello,

No... you should always change the oil filter. The oil filter is designed to keep your oil clean of particulates that can damage your engine. Not changing it every oil change can reduce your engine life.

If you find this information useful, please vote on this post. Thank you.

Regards,

Oz

Jan 16, 2011 | 2001 Ural Solo

1 Answer

How much engine oil does my 2005 crf 450 R need when changing oil and filter?


Engine oil:
Fill the crankcase with the recommended oil. Capacity: 0.73 US qt (0.69L) at oil and filter change Tansmision oil: Fill the crankcase with recommended oil. Capacity: 0.62 US qt (0.59L) at oil change.

Dec 07, 2010 | 2005 Honda CRF 450 R

1 Answer

Im changing oil on 05 rmz 450. i need to know oil capacity and where the oil filter is located


when changing both oil and filter use 1450mls of oil if only oil change use 1400mls but always check oil level after change

Sep 30, 2010 | 2005 Suzuki RM-Z 450

3 Answers

When i change the oil in my rf900r do i have to change the oil filter


it is allways good practice to renew the filter along with the oil

Jun 16, 2010 | 1996 Suzuki RF 900 RS2

3 Answers

For a honda 125 cbr how often do I change the oil and what type does it need?


oil change: every 1000km
oil type: silkolene comp 4 10w/30
quanity oil: 1000mls

Nov 03, 2009 | 2005 Honda CBR 125 R

2 Answers

My oil light is on, i have 39 miles on my gsxr 600. do i need an oil change or do i need to put oil in


Don't listen to the idot that said to change your oil at 39 miles! If you only have 39 miles on your bike and your oil light is on it mean there is low oil pressure so you need more oil in it. Cause the only reason that light goes on is when theres not enough oil in it. Not because you need an oil change.Also the oil change should be done at least every 3,000 miles but I do mine at 2,500. Also When you change the oil for the first time, you want to change the Filter as well. Every oil change there after you dont have to change the filter every time, you can do it every other oil change if you choose to. And always fill it up to in between the lines of your sight glass. and always makesure that after you put oil in it you start it up and for about 30-60 seconds then shut off and let sit for about an hour and add oil as needed.

Sep 18, 2009 | 2008 Suzuki GSX-R 600

1 Answer

Just had oil and grease. have been charged for 5.1 litres of oil, on the case it has 3300mils, they didnt change the oil filter. is the engine over filled with oil


Hi,


Verify Engine Oil Capacity according to model.
Check Oil Gauge.
Must change Oil filter at every Oil change.


Regards;
Hassan

Jul 26, 2009 | 1997 Suzuki GSF 600 S Bandit

1 Answer

I am wondering how much oil this bike holds?


the amount of oil should be marked on the crankcase by the filler plug. as for changing your oil, depends on where you live and what oil you use. people here in the USA change oil more regular than England, I believe oil in England to be a better quality. but a change of oil every 3-4000 miles is good, or every 6 months.

Mar 26, 2009 | 1976 kawasaki Z 750

1 Answer

Oil change


Ideally you should change the oil every 2000 km. Timely change of oil is vital for all 4 stroke engines. As a simple test after 2000 km touch the oil and feel the viscosity you will note the oil is no longer viscous and feels like water. Under extreme heat oil loses its viscosity faster. If you change oil at 2000 km regularly you will observe that your mileage and drive performance improves.

Nov 10, 2008 | 2006 Hero Honda Glamour

Not finding what you are looking for?
2006 CCM 404 Enduro Logo

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top CCM Experts

yadayada
yadayada

Level 3 Expert

64255 Answers

Jay Plesset

Level 3 Expert

2815 Answers

Tom Chichester

Level 3 Expert

26429 Answers

Are you a CCM Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...