Question about 2004 Buell Lightning XB9S

1 Answer

Starting chatter When i try to start my bike i get only alot of chattering. the engine doesn't try and turn over. lights work fine. Used to be that i could hold the clutch in and that would stop the klaking. could it be a starter problem?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,712 Answers

Check the ring gear on the clutch basket to make sure the teeth are all in good condition. Check the starter clutch and armature assembly and make sure that the teeth inside aren't chewed up.

Posted on Nov 10, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car doesn't start. when ignition is turned (new ignition) I hear a relay chatter and my horn sounds intermittely, Battery is new & tested goo


The chatter is due to low voltage. Check all the connections. The battery may have corrosion that lowers the voltage.

Oct 20, 2012 | 1999 Dodge Neon

1 Answer

Does the fuel pump relay on my 92 samurai chatter normally, or is this a sign of a ecm problem?The check engine light will not flash codes when I short the pins on the diagnostic connector.


No relay "chatters" normally, I would replace the relay first, they are inexpensive and that will eliminate that as the problem, plus those are alot cheaper than an ECM, I wouldn't suspect the ECM as causeing a relay to chatter! I say relay is the problem.
Good Luck !

Mar 14, 2010 | 1992 Suzuki Samurai

1 Answer

Interior light / electric locks chattering with no key in switch


Yes, you are missing something. The days of removing the battery cable ended with Generators. An Alternator will self destruct if you do that. Be certain to remove it and get it bench tested. Usually kills diodes and often regulator.

the doors clicking sounds like a problem in the door lock circuit, often in the door jamb. If you inspect and find broken wires in the door jamb, do not repair there, you need to replace the entire length. All repairs fail quickly. The wired need to be new and flexible.

On the no start with new battery, be sure to test the neutral safety switch.

Mar 11, 2010 | 1997 Buick Skylark

3 Answers

04 crf 250r.... the head has a chattering noise when running


Any chance the valve spring has collapsed? Cam shaft thrust washers missing? Cam shaft bearing gone bad?
abe5193.gif b3c3550.gif Please rate this solution. Thanks!

Jun 22, 2009 | 2005 Honda CRF 250 R

1 Answer

1995 jeep wrangler starting problems


would replace starter and inspect battery, cables/terminals also if problem still chattering u may have damaged the fly wheel the chattering is the starter not fully engaging the fly wheel. most likely starter but bad battery cables would also cause same symptoms hope this helps u

Apr 02, 2009 | 1995 Jeep Wrangler

1 Answer

CAmry Head lights and tail lights off


check innegration relay made to fuse block under dash driverside

Mar 09, 2009 | 1997 Toyota Camry

1 Answer

Starting chatter


Check the ring gear on the clutch basket to make sure the teeth are all in good condition. Check the starter clutch and armature assembly and make sure that the teeth inside aren't chewed up. 

Nov 10, 2008 | 2006 Hero Honda Pleasure

1 Answer

Starting chatter


Check the ring gear on the clutch basket to make sure the teeth are all in good condition. Check the starter clutch and armature assembly and make sure that the teeth inside aren't chewed up. 

Nov 10, 2008 | 2005 Hartford VR 150Z

1 Answer

Starting chatter


Check the ring gear on the clutch basket to make sure the teeth are all in good condition. Check the starter clutch and armature assembly and make sure that the teeth inside aren't chewed up. 

Nov 10, 2008 | 2001 Hartford VR 125X

Not finding what you are looking for?
2004 Buell Lightning XB9S Logo

204 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buell Experts

yadayada
yadayada

Level 3 Expert

69014 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

216 Answers

Are you a Buell Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...