Question about 2008 Benelli Tre-K 1130

1 Answer

Start but wont rev

Im the crazy donkey who put this bike in a ditch

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,712 Answers

Underwater. but pulled it out later and got it to start that night. My problem is after its starts i give it gas and nothing happens, just makes a bogging sound. my spark is good, i dont have points on this year motor and the timing has been idiot proofed so it really cant be changed. went through my carbs three times thinking its a fuel thing, but they looked pretty damn good. flushed the tank till clean, and xleaned up some corrosion from when it went under. transistoriized ignition, unadjustable mix carbs and a nontampering timing(right). im missing to much summer, any ideas, anyone.,water/moisture in the crankcase?? bad lubrication due to fudged up oil?? Im not even sure why putting it in water can offset your timing, unless its electronically controlled by one of the new fangled hall effect timing systems,,,

Posted on Nov 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

High revs cold


manual choke lever raises the engine reves to warm the engine by lifting the needle height and making the mixture rich, warm the bike up before moving off.

Jan 24, 2014 | 2011 Yamaha DT50R

1 Answer

Hi i have a 96 gsx600f it had an air leak but fixed it to some extent. I adjusted the air/fuel screws a bit an u had to rev it slow to build the revs up, once it hit bout 5k revs the throttel responce...


You pinched or routed the throttle cable wrong when you put it together. Take the tank back off and check it. Make sure you can hear the throttle plates closing when you release the throttle before you reassemble it.

Oct 25, 2013 | Motorcycles

1 Answer

My cr125 wont idel after stating can it be ajusted.


there is a little screw at the back of your carb next to your air box. kick your bike over and keep little revs on screw it clockwise (in) then start so slowly screw it anticlockwise (out) till your bike starts to rev a bit mor then release your throttle and it should tik over.

Aug 07, 2012 | 2003 Honda CR 125 R

1 Answer

My bike wont stop smoking and wont rev properly i carnt put the power down on the bike it feels like it is missing on full revs my bike is a kx 85 motocross 2007 model


If it's blue smoke, maybe an oil ring is broken. White smoke and water in the combustion chamber, black smoke carburation problems.

Feb 07, 2011 | kawasaki KLX 110 Motorcycles

1 Answer

Im told if you jump,off with a pick up it would distroy the cells in the battery.im told not to do this.i was to late what does a man do when he is in the pasture


It wont always destroy something.
What can happen, is the pickup battery can accept a lot more amps than the bikes charge system can produce.
So when the bike starts and you give it a big rev, it will try and produce maximum current which can damage the battery or charge system regulator etc

Push\roll start can be safer, as it then only tries to charge the bike battery, which it is designed for.

Jul 13, 2010 | 1990 kawasaki ZXR 750

1 Answer

I have a 1986 yamaha virago 700 that wont run properly


2 things need to be done first start your bike get a can of wd40 after your bike is warm and running spray around the carb jointsall 4 of them if your engine changes rpms up or down you have a intake leak ether your carb joint gaskets or o-rings need replacing or your carb joints are old and need replacing. at this point wont hurt to have you carbs cleaned also

May 03, 2010 | 1985 Yamaha XJ 700 X Maxim

1 Answer

I got a gilera runner 125.i bought it and the piston was broke so i put it in a garage and got it sorted and just gone threw mot with no problems but just went out first time in acouple days and the engine...


its sounds like its the rollers in the drive system...they wear flats on them!!...& this is why you wont have drive...it will be trying to like set off in 2nd gear insted of 1st....should be farily easy to sort...& not that expensive

Mar 31, 2010 | 2006 Gilera Runner VRX 200

1 Answer

When i rev up my bike i can hear a knocking noise


possible crank bearing failed and incorrect adjustment on the clutch cable or the clutch it self

Oct 25, 2009 | 2002 Beta Alp 4T 200

1 Answer

Rs 125 wont redline.....please help!!! PLEASE.


there's a rev limiter . Im not sure of your bike model but a simple google might help.

Mar 13, 2009 | 2008 Aprilia RS 125

Not finding what you are looking for?
2008 Benelli Tre-K 1130 Logo

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Benelli Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Connie Richardson

Level 1 Expert

15 Answers

Jazz Boyce
Jazz Boyce

Level 1 Expert

728 Answers

Are you a Benelli Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...