Question about 2000 Bajaj Chetak 150

1 Answer

No power I need some help.... I put a new battery in my chetak 150 and without charging it went for a ride. When I pulled into the gas station to fill up I cut her off and that was the last I saw of any power. I tried to jump it and got nothing. I charged the battery and still get nothing. I'm at a loss. If anyone has any clue as to what I might have done or what I can do to fix it

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,712 Answers

Please let me know. ThanksCheck your connections to your fuses and to your grounds. Assuming you are connecting the jumpers up to the battery terminals and you charged your battery back up I can only assume that you have power at the battery. And if you checked your fuses and they are good, then it must be a problem either: 1. between the positive battery terminal and the fuses 2. between the negative battery terminal and your ground(normally a bolt on the frame) 3. between the fuses and every component on your bike(which could be your ignition switch failing, but unlikely) These connections often fail because of either loose connections or corrosion. So just a quick inspection of each connection can shed a lot of light on the problem. ,,,

Posted on Nov 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just picked up a 2006 Bajaj Chetak from a guy who runs a local tobacco shop around the corner. It was ridden a total of about 1630 miles by a little old Indian man who is the original owner. It runs and...


You have a dead battery. Add distilled water to the battery and then charge it up. Riding the scooter regularly will keep the battery charged, but it will not re-charge a battery once it has gone so dead that the starter will not turn over. Worst possible case, buy a new battery for about $26.

Nov 27, 2010 | 2006 Bajaj Pulsar 150

1 Answer

Have a piaggio fli 150 scooter,batteri went dead ,havent use it,bought new batteri when i connect second cable to batteri,engine starts without me putting kei in engine,help me please


Hi
Either the starter solenoid or the starter button is stuck on
Make sure it is connected to the correct pole of the solenoid (no other wire connected)

Ride Safe
Bike-Doc

Jul 17, 2010 | Aprilia Classic 125 Motorcycles

1 Answer

2004 Bajaj Chetak headlight repair


Hi Mixonfineart, I am sorry you can't find the first and best tool you ever bought for your Bajaj but despair not for a mere $0 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
Vespa VBB VBA Bajaj Headlight Upgrade Fail
Vespa GTS 125 How to Change your Headlight Bulb
http://www.carlsalter.com/download.asp?p=150
http://www.scootermasters.com/manuals/pdf_255.pdf https://dl.dropboxusercontent.com/u/68950350/Bajaj%20Manuals/Chetak-2003-Owners-Manual.pdf

Jul 10, 2010 | 2006 Bajaj Chetak

2 Answers

Sputters and stops running.


Since it still starts and runs, i would try to save money and buy a bottle of Techroline (Chevron) gas additive and put in1/2 bottle w/full tank of gas. By the 2nd tankful and 2nd half of bottle you should notice a big improvement, but if no change take it to a competent scooter mech....Good Luck to you friend.....tim

May 12, 2009 | 2000 Bajaj Chetak 150

1 Answer

Power issue


Check your connections to your fuses and to your grounds. Assuming you are connecting the jumpers up to the battery terminals, and you charged your battery back up, I can only assume that you have power at the battery. And if you checked your fuses and they are good, then it must be a problem either: 1. between the positive battery terminal and the fuses 2. between the negative battery terminal and your ground(normally a bolt on the frame) 3. between the fuses and every component on your bike(which could be your ignition switch failing, but unlikely) These connections often fail because of either loose connections or corrosion. So just a quick inspection of each connection can shed a lot of light on the problem.

Nov 20, 2008 | 1995 BMW R 100 GS

2 Answers

Bad battery


Don't rely on on whether the bike will start at a gas station to determine if the charging system is working. Get the multimeter out and do a proper test. Should be getting about 14.5 volts @ around 3K RPM. It's too easy of a test to to just skip. If it is charging then start looking for something else. Was the new battery properly charged to begin with? Loose battery connection? I suppose the GPS could be too much but you said that it was dying last november, so I would suspect something else. P.S. you need a properly charged battery to get an accurate reading for the charging test.

Nov 20, 2008 | 1989 BMW K 100

1 Answer

Lake of power


please let me know. ThanksCheck your connections to your fuses and to your grounds. Assuming you are connecting the jumpers up to the battery terminals and you charged your battery back up I can only assume that you have power at the battery. And if you checked your fuses and they are good, then it must be a problem either: 1. between the positive battery terminal and the fuses. 2. between the negative battery terminal and your ground(normally a bolt on the frame). 3. between the fuses and every component on your bike(which could be your ignition switch failing, but unlikely). These connections often fail because of either loose connections or corrosion. So just a quick inspection of each connection can shed a lot of light on the problem. ,,,

Nov 10, 2008 | 2005 Kymco Xciting 500

1 Answer

Bad battery


though if it was a problem it would have blown the 10amp fuse????Don't rely on on whether the bike will start at a gas station to determine if the charging system is working. Get the multimeter out and do a proper test. Should be getting about 14.5 volts @ around 3K RPM. It's too easy of a test to to just skip. If it is charging then start looking for something else. Was the new battery properly charged to begin with? Loose battery connection? I suppose the GPS could be too much but you said that it was dying last november so I would suspect something else. P.S. you need a properly charged battery to get an accurate reading for the charging test. ,,,

Nov 10, 2008 | 2003 HM Motard 450 F

Not finding what you are looking for?
2000 Bajaj Chetak 150 Logo

Related Topics:

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bajaj Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4473 Answers

yadayada
yadayada

Level 3 Expert

60792 Answers

Are you a Bajaj Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...