Question about 2008 Piaggio XEvo 250

Open Question

Piaggio x-evo top box ? Does a x8 fit ? Where can I buy a rack?

Does an x8 top box fit this bike? Do I need different rack?

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: engine cuts off when idle. piaggio x8 125cc 2007

try to adjust your idle rpm,also try to check if ur battery works fine coz busted batteries affects the proper operation of the motorcyle

Posted on Apr 09, 2013

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How much fork oil for piaggio x8 125 2007


With the forks compressed all the way down, fill each fork leg 6 inches from the top.

Aug 20, 2017 | Piaggio Motorcycles

1 Answer

Can I put a water cooled piaggio power 50cc carb on a piaggio nrg 50cc air cooled bike?.


Hi, Noel after careful deliberation 4 out 5 Piaggio Gods give this one a thumbs up, but just to be on the safe side you should give your local dealer's parts/service department a call to confirm. For more information about your question and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.49ccscoot.com/manuals/Piaggio-NRG-Power-Purejet_Shop_Manual.pdf
PIAGGIO NRG POWER PUREJET User Manual
https://www.oemmotorparts.com/oem2.asp?M=piaggio

Nov 14, 2016 | Piaggio Motorcycles

1 Answer

What causes oil leakage on piaggio x8 400ie oil filter box


First, it is made out of plastic. I would get a new seal, silicone it on, then use more silicone on that, then mount it. Let it set for an hour, then add the oil.

Sep 05, 2015 | Cars & Trucks

2 Answers

Piaggio x8 runs rough when warm


Maybe the spark plug breaking down under load when warmed up.Try another spark plug, but make sure it is the recommended one

Mar 03, 2014 | 2006 Piaggio X8 125

1 Answer

Engine cuts off when idle. piaggio x8 125cc 2007


try to adjust your idle rpm,also try to check if ur battery works fine coz busted batteries affects the proper operation of the motorcyle

Apr 09, 2013 | Piaggio Motorcycles

1 Answer

Bike wont start after recharging battery


may need new battery, a certain amperage is needed to make the magnet pickups work. try jumping of a car battery to test

Feb 20, 2013 | 2006 Piaggio X8 125

1 Answer

Bike cuts out when taking off and engine management light comes on


fuel air is my first thoughts

  • NOTE: A rich problem gets worse as the engine heats up.

  • NOTE: A lean problem gets better as the engine heats up.

Oct 29, 2012 | 2006 Piaggio X8 250

1 Answer

2006 Piaggio X8 125 My Piaggio x8 125 LC loses power at max throttle! At first it was at max throttle (100 kph) and felt it was runing short of petrol or choked up. Now it only runs at 3/4 throttle (70 to...


Hello crosby, it still sounds like a fuel delivery problem or fuel mixture. Also a possibility is a restricted exhaust. Like carbon buildup that is creating too much back pressure. The carb being "blown out" is not going to properly clean it. The best way to clean all the jets and passages is to remove it & have it boiled or ultrasonic cleaned. The not being able to kill problem is a wiring problem. The spark is not being shut off, (voltage) Trouble shoot these areas and let me know what you find. I hope this helps.

Oct 03, 2011 | 2006 Piaggio X8 125

1 Answer

2006 Piaggio X8 125 My Piaggio x8 125 LC loses power at max throttle! At first it was at max throttle (100 kph) and felt it was runing short of petrol or choked up. Now it only runs at 3/4 throttle (70 to...


Hi, Crosby you can thank Scooter Therapy for this novella. There are few things you need to look at when trying to troubleshoot your scooter for power loss. How does it sound? If you run it wide open throttle when warmed up, does it peak out? or stutter? is it loud, or very quite the symptoms can help decide what to try. When you are going full throttle, the engine should get to a high RPM and sound smooth here are a few things you should look for:
1. Plugging air intake- will start well cold, but be hard to warm up and not reach top speed. The engine will stutter at high RPM.
2. Open air intake- to much air or air cleaner is disconnected- engine will not have power at high speed, make vacuum cleaner sound. Acts like it's running out of gas. ( sounds almost the same as a dirty carburetor.)
3. Plugged exhaust port the engine sounds and runs good, but has no power. Slow to take off. Same as plugged muffler, but if the muffler is plugged you get a very smooth exhaust note at idle. Humming instead of pop pop pop pop.
4. Fouled spark plug- backfire. If you get backfire, pretty good chance the plug is fouled.
5. On models with belts, the gear ratio drops as the belt gets thinner (most hondas have belts).
6. On a moped with high mileage, the belt will cause slow top end speed if worn thin.
7. If you have a bike with chain drive in an oil bath and you "OVERFILL" the oil amount in the chaincase, that makes for slow running as it requires too much power to turn the oil.
8. If your engine does not rev up well and stutters or sputters, like when it is cold with the choke on, the engine is running too rich. (too much fuel).
9. Is the air filter soaked with oil? Clean with soap and water!
10. Is the air opening in the airbox plugged? Very common for a spider or mud wasp to build a nest in one of the intake holes.
11. On some scooters it is common to get a leaf stuck in the intake port of the airbox, causing a 10mph drop in top speed.
12. Don't try to adjust the screws on the side of the carb to get lean or rich, as they are for the idle circuit only.
13. The idle air screw should be about 1 1/2 turns out on most scooters.
14. Say your engine revs but kind of wheezes or acts like it runs out of gas it is common to have a buildup of hard carbon on the inside diameter of the hole in the main and pilot jets, and it must be carefully removed.
15. If your moped does not idle the pilot jet is likely plugged.
16. Anytime a moped has not been used for 1 year or more, and still has the same fuel in it, good chance you will need to clean the jets.
17. The poor quality of today's gasoline has made this a rather steady bet.
18. Mopeds are affected more than most vehicles because the small size hole the jet requires is easily plugged, even by thick oily fuel, or water.
19. Drain your carb once in awhile! Most have a screw of some type at the bottom (where the drain needs to be) of the carb.
20. Make sure the air boot to the airbox is not on wrong, kinked, hard and shrunken.
21. Don't oil the air filter if you got the stutters.
22. On some scooters, you can leave one snap loose on the airbox lid to allow it to crack open, to get full rpm.
23. "WARNING" too much lean out on the gas, and since the fuel cools the piston, the piston can "MELT"
24. Still slow? Check the muffler tip. Make sure no carbon buildup is inside the tip, stick something in as far as it will go.
25. Common on some scooters to have the tip bent over on a curb, then carbon up solid. common of all types to have the whole muffler plug.
26. When you have the muffler off, is it heavy?
27. Can you get the baffle out to see if the holes are plugged?
28. Check the exhaust port on the cylinder.
29. If you can't see all the way into the piston, use a mirror and a flashlight to make sure the piston is ok and the port is not plugged where it meets the piston.
30. Common on all models to plug here, Just scrape it out so the hole is full size again.
31. Don't worry about the small film on the inside of the port, I am talking about a very thin film that forms a wall in the exhaust port right next to the piston.
32. A 1 1/2 inch hole can be reduced to the size of a pea...... With a thin film of carbon.
33. If you can see the piston ok, it's not the problem.
34. If you are in doubt regarding your exhaust pipe being plugged, put your hand behind the muffler to see how much pressure is expelled. compare to another bike.
35. It should blow pretty good and have a distinct pop pop pop pop sound while idling, not a steady humming.
For more information about your question and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
2006 Piaggio 125 LC power loss Scooter Doc Forum
Modern Vespa No power at full throttle figured out
Piaggio X8 125 200 Workshop Service Repair Manual Download Manuals... $15
Genuine Piaggio scooter parts spares Fowlers Parts
Piaggio X8 125 2006

May 09, 2017 | 2006 Piaggio X8 125

1 Answer

Hitch mounted bike rack that doesn't seem to fit Envoy


there are draw bar extensions you can buy that will extend the rack beyond the tire. check with your local trailer parts store.

Jun 24, 2009 | GMC Envoy Cars & Trucks

Not finding what you are looking for?
2008 Piaggio XEvo 250 Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Piaggio Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4521 Answers

Joseph Hoffmann

Level 3 Expert

1702 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

15137 Answers

Are you a Piaggio Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...