Question about Honda Motorcycles

Open Question

I have a honda trx250te atv it starts and runs full throttle

It starts and runs wide open

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3567 Answers

SOURCE: honda 1300c backfire through carb at wide open

Try balancing ans syncronising the carbs.
BALANCE THE CARBS
Turn the throttle screw on the LEFT carb one half turn inward. Now start the engine and get it warmed up. With the engine running, remove the RIGHT spark plug wire. Adjust the idle speed on the left carb to the point where the engine just can't quite stay running and dies. Now put the loose spark plug wire back into place.

Now turn the throttle screw on the RIGHT carb one half turn inward. Restart and rev the engine. Next, remove the LEFT spark plug wire. Adjust the idle speed on the right carb to the point where the engine just can't quite stay running and dies. Now put the loose spark plug wire back into place.

Turn the idle screw on each carb EXACTLY ONE QUARTER turn outward and restart the engine. The engine will be probably be idling very fast. Adjust both the idle screws equally from this point to get to the desired idle speed.

SYNCHRONIZE THE CARBS
Remove the air filter and rubber fittings to allow you to see into the throat of both carbs. You may need a mirror to see inside. You need to be able to see the slides go up and down when you twist the throttle. Now turn the fitting where the cable goes into each carb such that there is just a bit of slack in the cable, 1/16" is plenty. Lock ONE of the cable adjusters down tight. All further adjustments will be made on the other carb.

With the motor turned off twist the throttle very slowly while looking at the slides. Both slides need to begin lifting at the exact same moment. If the slides don't raise at the exact same time then slowly twist the throttle until the locked adjuster slide just barely starts to move. Hold the throttle still and turn the adjuster on the other carb so that the slide on that carb just barely starts to move also. Now recheck the slide movement timing. Do this process until the slides on both carbs begin to raise at the EXACT same moment. Lock down the loose adjuster and re-check the slides.

Please rate this solution. Thanks!

Posted on Mar 30, 2009

jpolicky
  • 40 Answers

SOURCE: honda 1300c backfire through carb at wide open

If you have used Dyno jet kit I have had a kit come through with smaller main jets than the stock ones causing it to run way to lean.

Posted on Jun 01, 2009

SOURCE: 2004 Honda Shadow Aero stalls

There seems to be low gas level in the float chamber of the carburator.
Clean the carburator and check the float level and reset.
With the choke 'on' and if you hit the throttle it will die because there is a restriction of the air flow to the carburator.

Posted on Jul 19, 2009

  • 224 Answers

SOURCE: My Honda innova 2006 model has a clicking noise

sounds like valve train problems

Posted on Aug 05, 2009

  • 8404 Answers

SOURCE: I have a kawasaki 650 prairie atv. driving the atv

I think you have a fuel obstruction.

Posted on Nov 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What can i do to keep my 2004 honda 250 recon from being so cold natured


Are you comfortably taking apart, cleaning and checking your carburetor? Got a lot of experience with the recons - cleaning that carb and checking it out is the #1 place I'd start. Here are your vacuum lines - for the TE TM - I can show you exactly how to tear down, check, set and put back together that carb or most of any other. Just let me know - Thanks, Justin M. 17 South Industries, LLC 2002 2003 2004 HONDA RECON TRX250TM TRX250TE CARB HOSE ROUTING - there's your routing - check all of the hoses first. If they're all fine - take the carb off. If you don't have the specs/tech info just let me know and I'll make sure you see how to do it by the book.

Apr 10, 2016 | ATVs

1 Answer

Why does my ATV bog down and die when I keep the throttle wide open?


If you are lucky, you might just need new fuel filter and the fuel bowl cleaned out, and maybe new air filter. If not so lucky you need carburetor rebuilt. Backfire is usaully caused by engine running too lean ( too much air for the amount of fuel present). Fuel bowls get gunk in them and the fuel needles and fuel jets get varnished up. The accelerator pump gets worn out gaskets and/or bellows and doesn't give the right amount of fuel mist when you accelerate.

Full Choke is indicative of a motor starved for fuel

Mar 04, 2015 | ATVs

1 Answer

How to fix stuck wide open throttle


Rusted or dirt inside cable need to replace throttle cable

Aug 20, 2014 | Polaris ATV

1 Answer

Have honda trx250te atv. It will run when I spray carb cleaner into carb but will not stay running. I looked for carb abstructions and did not see any. Do you have any suggestions


the fuel feed in the tank could be blocked ! when you turn fuel on does the fuel bowl fill up ? did you remove all jets and the emulsion tube above the main jet ? float needle not stuck ? clean all parts and blow out all parts and holes where they fit with an air line ! refit and should be ok !

Mar 04, 2014 | Honda Motorcycles

1 Answer

Honda trx250te wiring diagram


Cannot understand your question, does not seem to be words or a question?

Jan 14, 2014 | ATVs

1 Answer

When started it runs at full bore the butterfly on carb is wide open


Sounds like the Governor is not connected to the throttle.

Jan 23, 2011 | Honda Garden

1 Answer

Atv starts but runs wide open only even though the throttle cable looks like it works fine


Your bike will only run at full throttle if your cable or main jet needle are stuck in the full throttle position .Take your throttle cable off and check that its freely working inside the outer caseing .

Mar 22, 2010 | 1976 Honda CB 100

1 Answer

Moified 2001 honda elite-s scooter overheats on long trips.


You shouldn't need to full throttle constantly. , or at least let up on it periodically so it can dump some heat

Jun 17, 2009 | 2005 Honda Dio

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...