Question about Yamaha XV 535 Virago DX Motorcycles

1 Answer

Virago 535 will not back down to idle immediately

After letting the accelerator drop or pushed to idle the engine stays accelerated for a short time.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check throtle cable is routed properly and make sure cable is lubricated

Posted on Feb 15, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

co7196
  • 3433 Answers

SOURCE: 1990 yamaha virago 535 sat two years

If it is possible to start at all. Fresh fuel fresh engine oil good battery. You may have the following problems; Corroded and blocked carburetor fuel system, bad wire connections piston ring set up.... I hope it was kept indoors and the fuel was drained out before it was left sitting. Good luck, they are nice bikes.

Posted on May 29, 2009

  • 125 Answers

SOURCE: 1996 honda VT1100c2 backfiring & missing when accelerating

Replace Fuel Filter.
Test fuel pump output.
Remove and service carburetors.

Posted on Jun 15, 2009

  • 3567 Answers

SOURCE: 1990 Yamaha Virago 535 Parts interchangeable with 2001 virago 250

Sure mirrors, nuts, bolts and screws. Maybe a fender and a bit of other stuff. But for the most part not much will match up and now you have this ugly monster in your garage and your next job is to figure out exactly how you are going to get rid of the da-- thing. Look a bit harder and get a match for your bike. Now you have something worthwhile.

A “very helpful” rating for this answer? Thanks!

Posted on Jun 18, 2009

finish line
  • 207 Answers

SOURCE: how do I check the alternator on my 1987 yamaha

you want to check your stator bikes dont have altenators you can get the specific specs from your dealer and run a resitance test to see how many volts it is putting out but 9 out of ten times the stator has nothing to do with the rectifier going out expecialy with that old of a bike

Posted on Jun 27, 2009

bazzz7071
  • 338 Answers

SOURCE: 2001 yamaha ttr 250, starts, idles ok, bogs at acceleration

Has the bike been stored for any long length of time?
old fuel in the carburetor will turn to a varnish like residue blocking the jets,or possibly water in the carburetor.

Posted on May 03, 2010

Testimonial: "The bike was not stored and was ridden regularly, but it still sounds like it could be the carburetor. Thanks for your insight."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why doesn't it drop down to idle when I stop?


Is it always idling high?? Or just when you accelerate?? If its running high all the time, suspect a vacuum leak( unplugged vaciuun hoses, intake manifold leak, etc.) If it only does it when you accelerate and it wont come back to idle, suspect a bad tps or something sticking and letting your throttle to stay open.

Feb 06, 2016 | 2002 Toyota Camry

1 Answer

I can not get an even tickover


Hi, Anonymous and the usual suspects are:
1. Idle speed improperly adjusted.
2. Air fuel mixture screws not properly adjusted.
3. Inlet system air leak.
4. Leaking accelerator pump.
5. Loose low-speed jet.
6. Plugged low-speed jet.
7. Contaminated or plugged low-speed circuit.
8. Enrichner valve/choke not seated or leaking.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://viragohelp.com/virago-hitachi-carburetors
http://viragohelp.com/virago-carburetor-cv
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-16_110.pdf

Jul 03, 2014 | 1998 Yamaha XV 535 Virago DX

1 Answer

Poor acceleration


Hi, Anonymous and the usual suspects are:
1. Throttle cables misaligned or misrouted.
2. Damaged or restricted fuel tank venting system.
3. Intake system air leak.
4. Vacuum piston malfunction.
5. Accelerator pump leaking or no output.
6. Plugged bowl vent or overflow.
7. Fuel level in bowl too low.
8. Restricted fuel supply passages.
9. Plugged jets or passages.
10. Worn or damaged needle or needle jet.
11. The enrichner valve not seated or leaking.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Virago 535 Starting and running problems
https://yamahaclub.com/forums/topic/11137-virago-535-loss-of-power
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2005/LIT-11626-18-21_1000.pdf

Apr 08, 2012 | 1997 Yamaha XV 535 Virago DX

1 Answer

My 1995 Yamaha XV535 will not idle properly. I've


Hi, Jerry and the usual suspects are:
1. Idle speed improperly adjusted.
2. Air fuel mixture screws not properly adjusted.
3. Inlet system air leak.
4. Leaking accelerator pump.
5. Loose low-speed jet.
6. Plugged low-speed jet.
7. Contaminated or plugged low-speed circuit.
8. Enrichner valve/choke not seated or leaking.
9. Multi carburetors out of sync and need to be balanced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Virago XV250 Choke and Idle Problem Premium fuel
http://viragotech.com/newtech/Only%20starts%20idles%20on%20choke%20dies%20when%20you%20give%20it%20gas%20(SOLVED).htm
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2005/LIT-11626-18-21_1000.pdf

May 25, 2011 | 1995 Yamaha XV 535 Virago DX

2 Answers

1994 virago idles fine won,t accelerate only runs with choke on


an absolute GUESS/Sudjeswtion, perhaps one of the diaphrams has a split/crack, thus y works with choke???

Dec 03, 2010 | 1994 Yamaha XV 535 Virago DX

1 Answer

Low idle - yamaha virago 535(1994)


Hi, Ramberry and the usual suspects are:
1. Idle speed improperly adjusted.
2. Air fuel mixture screws not properly adjusted.
3. Inlet system air leak.
4. Leaking accelerator pump.
5. Loose low-speed jet.
6. Plugged low-speed jet.
7. Contaminated or plugged low-speed circuit.
8. Enrichner valve/choke not seated or leaking.
9. Multi carburetors out of sync and need to be balanced.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://viragotech.com/newtech/535%20runs%20for%20a%20while%20then%20dies%20(SOLVED).htm
Yamaha Virago 1100 Idle
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2005/LIT-11626-18-21_1000.pdf

Jun 05, 2010 | 1994 Yamaha XV 535 Virago DX

1 Answer

Hi,Hi Have a 535 xv 1999 their is a Lack of power


Hi, Chris25591 and the usual suspects are:
1. Throttle cables misaligned or misrouted.
2. Damaged or restricted fuel tank venting system.
3. Intake system air leak.
4. Vacuum piston malfunction.
5. Accelerator pump leaking or no output.
6. Plugged bowl vent or overflow.
7. Fuel level in bowl too low.
8. Restricted fuel supply passages.
9. Plugged jets or passages.
10. Worn or damaged needle or needle jet.
11. The enrichner valve not seated or leaking.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Virago 535 Starting and running problems
https://yamahaclub.com/forums/topic/11137-virago-535-loss-of-power
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2005/LIT-11626-18-21_1000.pdf

Mar 05, 2010 | 1999 Yamaha XV 535 Virago DX

2 Answers

Virago 535 not starting


Sounds like:
A: The starter clutch is slipping and not letting the starter engage the crankshaft
B. The carbs need to be cleaned. If ti has sat unused for more than 30 days, the pilot jets are clogged up causing it to stall (off choke) and be sluggish on acceleration off idle.

Aug 31, 2009 | 1989 Yamaha XV 535 Virago DX

1 Answer

Electical failure when accelerating


Measure the charging system.Battery, regulator/rectifier and stator output volts.At 3000rpm you should see on your battery 13,5-14,5V with your high beams on.Your battery disconnected should show 12,5V.

Jun 05, 2009 | 1992 Yamaha XV 535 Virago DX

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

dhnguyen

Level 2 Expert

281 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1144 Answers

Tony

Level 3 Expert

2600 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...