Question about kawasaki Motorcycles

Open Question

How to use idle adjuster 2003 kawasaki prairie 650

Adjusting knob turns left or right with no affect on idle

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2712 Answers

SOURCE: Clutch cable adjusters

Bowden cables like your clutch cable work on the law of the lever. Think of lifting up a heavy weight hanging on a rope using a lever balanced on a fulcrum. The rope is in tension and the fulcrum is in compression. To adjust the point of lift you could either vary the length of the rope or adjust the height of the fulcrum. The outer sleeve of your clutch cable is made out of plastic-coated steel, square-section wire and is resistant to compression forces along its length. This outer sleeve works as your fulcrum and, because it is flexible, lets you put it where it is needed - at the end of your handlebar. The cable inner is like the rope in the lever example and resists only stretching forces. It is threaded down through that snaking fulcrum back to where control movement is needed. The cable adjusters let you fine tune the length of the fulcrum, and therefore the lift range of the inner cable.,,,

Posted on Nov 10, 2008

Ad
  • 3567 Answers

SOURCE: my idle screw for the rpm

Turn both the idle screw and the air screw inward until they LIGHTLY seat. now turn them outward one and one half turns.
Repair is done!

Please rate this solution. Thanks!

Posted on Mar 28, 2009

  • 86 Answers

SOURCE: how does a 2002 kawasaki ninja 250r act if the clutch isnt adjust

if there is no free play when pulling the lever in, the bike will most likely take off from first gear, but when you throttle it, the clutch will most likely slip. if the lever is to loose, lots of free play, you may have a hard time getting it in gear. approx 1/4 inch free play with the lever and it will work normal... unless its ready for a new clutch. hope this helps...

Posted on May 27, 2009

  • 434 Answers

SOURCE: 2002 Kawasaki Prairie 650

Either the switch on the handlebars isn't making contact. Or the shift motor on the front differential is broke.

Posted on Jul 07, 2009

  • 6 Answers

SOURCE: i have a 2002 kawasaki prairie 650. i think i have

Check the seal behind your water impeller there are o rings back there if one of them goes bad you will leak antifreeze into oil, your impeller is run by the oil pump i believe, you should not see oil in the water also your bike will run fine but when hot will foul the plug with water look for white smoke sometimes and the smell of anti freeze on start up
i have a 400 4x4 doing the same thing new piston rings and top end now lossing water but runs great oil looks real thin
took to the dealer to fix this week will let you know how i make out.

Posted on May 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many turn it take on the air mixture screw to get my 2010 Kawasaki 360 4x4 to start?


For the initial settings - 03-12
- lightly seat the pilot all the way to the back - lightly, too much torque and you'll ruin the o-ring in there - then back out the pilot screw 1 & 1/2 turns. From there - you let it run for 10 minutes or so and then adjust the idle to 1,300 +/- 50 rpm - turn your handlebars left and right after adjustment of the throttle lever to make sure it's okay and not binding up - and do your adjustment from the throttle stop screw. According to the specs, once you set that pilot at 1,300 +/- the rest of the adjustment is done with the throttle stop screw. If you do all that and it's still not picking up fuel - definitely give the intake/carb boot a good look over for any cracks or anywhere vacuum could escape - and if it still doesn't pick up the fuel - give the throttle set screw a turn or two. Had a 2000 Yamaha XT225 carb I rebuilt a few weeks ago - adjusted everything as instructed - but it wasn't picking up the fuel. I gave the throttle set screw about a 1/3 turn in to put a little nudge on the throttle and it fired right up. All The Best and Good Luck - Justin Lee, 17 South Industries, LLC

Apr 30, 2016 | kawasaki 2010 Prairie 360 4x4

1 Answer

My 2003 Kawasaki prairie 360 when u install the hose from the air box it will only idle u can not rev it up take the hose off and it runs fine


2003 360 Prairie 4x4 cutting out... I'm stumped! - Kawasaki ...

www.kawasakimotorcycle.org > ... > Kawasaki ATV and Mule
Dec 14, 2011 - This 360 4x4 has me stumped. ... 2003 360 Prairie 4x4 cutting out. ....It idles just fine, it has perfect throttle response, it just won't rev without ... 2006 Prairie 4x4 governor prob?
Oct 1, 2009
04 Prairie 360 Knocking when Idling and Belt Light on.
Jan 26, 2009
Older Prairie Tune Up Questions
Sep 19, 2008
Prairie 360 (Limp Mode)
Jan 4, 2005
More results from www.kawasakimotorcycle.org

Nov 19, 2015 | kawasaki Motorcycles

1 Answer

99 kawasaki prairie 300, 2x2. It ideas a little funny with chicken off it dies out within 5 sec. Can't find a good idle I guess. It had an air intake thing u twistdown by your left foot do I touch it.


Hi Joseph, I am sorry you can't find the first and best tool you ever bought for your Kawasaki but despair not for a mere $5 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
Two Stroke Scooter ATV Carburetor Settings And Adjustments 1of4 Basics... https://www.tradebit.com/filesharing.php/search/0/1999+kawasaki+prairie+300

Nov 01, 2015 | kawasaki Motorcycles

1 Answer

Kawasaki forum, I have a 2002 kawasaki prairie 650 4x4 that will not switch into 4 wheel drive. It stays in 2 wheel only. Help please


Honda FourTrax & Kawasaki Prairie 650 ' Outdoor Life

www.outdoorlife.com/articles/gear/.../honda-fourtrax-kawasaki-prairie-6...
Honda decided not only to get into the 500cc-class automatic 4x4 camp, but to do ...by three electronic shifting programs: one for high-speed driving on easy trails; ... this innovation: Kawasaki made the Prairie 650 capable of starting in gear.

Sep 12, 2015 | ATVs

1 Answer

Where is the idler screw on a Kawaski 360 prairie atv


To ajust the idle there is a nob that you turn that come from the carb,

Jun 10, 2013 | kawasaki 2007 Prairie 360 4x4 Camo

1 Answer

Low idle


mixture is non adjustable but idle speed is. located under the carb near the breather cover on the right hand side is a knob that will turn to set idle speed

Aug 05, 2012 | 2001 kawasaki VN 1500 Vulcan Classic

1 Answer

Looking for idle adjustment on 2003 cr 250


the idle adjustment is the choke knob turn it left or right to increase or decrease idle

Mar 19, 2011 | Honda CR 250 R Motorcycles

1 Answer

2007 kawaski atv 650 brute force it grinds gears from neutral to high and low and reverse .is there adjustment to correct problem. thank you .


Sounds like it's idling to fast! there is a knob on the right side under the gas tank to adjust the idle.

Jan 28, 2011 | kawasaki Cycling

1 Answer

How to lower the idle on a 2002 yamaha 650 v-star classic?


under the left side of the gas tank you will see i black knob/screw at the end of what looks like a hose. the knob faces the rear of bike. that adjusts the idle. its real easy to find and the only adjustment you can make to the carbs.

Apr 01, 2009 | 2002 Yamaha V Star Classic

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

279 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4535 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

bazzz7071
bazzz7071

Level 2 Expert

342 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...