Question about kawasaki Ninja ZX10 R Motorcycles

Open Question

How do you remove the seat on a 1990 kawasaki ninja

A 1990 kawasaki ninja

Posted by on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 86 Answers

SOURCE: how does a 2002 kawasaki ninja 250r act if the clutch isnt adjust

if there is no free play when pulling the lever in, the bike will most likely take off from first gear, but when you throttle it, the clutch will most likely slip. if the lever is to loose, lots of free play, you may have a hard time getting it in gear. approx 1/4 inch free play with the lever and it will work normal... unless its ready for a new clutch. hope this helps...

Posted on May 27, 2009

  • 149 Answers

SOURCE: how to remove front fairing 250 kawasaki ninja

there are small allen bolts or lock screws.. take them out and it should just come off

Posted on Aug 30, 2009

  • 34 Answers

SOURCE: would the fairing parts of a 2006 kawasaki ninja

Yes I do believe they do. Try going to Look in the shopping section on the left of the homepage. You will want to use the parts fische and load the info for your bike. It allows you to see what the dealer parts counter can see. See if this helps. I'm pretty sure the 250 ninja really didn't change until 2008 when it got the BIG overhaul

Posted on Nov 02, 2009

Testimonial: "Thanks Fixya"

  • 6966 Answers

SOURCE: kawasaki ninja 636 won't start

Hi and welcome to FixYa,

On your post "...does not fire..." initial checks would be for:

  • consistent IGN + 12 on the red wire going to all the ignition coils even when cranking;
  • pulsating voltage on the other wire of each ignition coil coming from the ECU when cranking.

Incidentally, if the bike has been sitting for 2 months, you may want to check quality of fuel and/or replace it. Further checks maybe required on the fuel delivery system. Try of a quick fix would be adding / spraying injector cleaner.

Good luck and thank you for asking FixYa.

Posted on Nov 14, 2009

Thermo King
  • 593 Answers

SOURCE: 2008 kawasaki ninja 650 R generator cover replacement

You can take the cover off, nothing should fall out.

Posted on Jan 02, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do i remove the drivers seat on a 2008 zx10

Remove the two small panels under the seat. Then remove the screw in center holding seat in place.

Apr 16, 2012 | 2008 kawasaki Ninja ZX10R

1 Answer

How do you get to the battery without ripping off the seat?

you cannot the battery is under the seat which must be removed by firstly removing the rear seat with the key and there is one 10mm bolt at back of front seat once removed the battery is easily accessed

Sep 07, 2011 | 1996 kawasaki ZX-6R Ninja

1 Answer

How doyou remove the seat on a kawasaki er-6f

There is a seat lock provided under the rear painted fairing. Its on the left hand side of the vehicle Turn the lock to unlock the seat.

Also refer to Owners Manual for further details

Jul 05, 2011 | 2011 kawasaki Ninja 650R

1 Answer

Where is the air filter on a 1995 kawasaki ninja zx6r

The air filter on this bike is under the fuel tank, you will have to remove the seat and there will find the bolt holding the tank down, once this bolt is removed the tank will then just lift up.

Jun 07, 2011 | 1995 kawasaki ZX-6R Ninja

1 Answer


Under the tail light is a lever pull out on it and lift the back of seat

Dec 11, 2010 | 2008 kawasaki Ninja 250R

1 Answer

How do I raise the seat up on a 2001 kawasaki zx9 ?

If it's like my 2003 ZX9, to take the riders seat off you open the rear compartment by removing the passenger seat, the front bracket that hold the the seat has two 8mm bolts and a screw. Unscrew the screw and remove the bolts and slide or remove the bracket and then the riders seat lifts up.

Jul 23, 2010 | 2001 kawasaki ZX-9 R Ninja

1 Answer

Kawasaki ninja 600, 2001

no you simply undo the bolts at the front off the tank remove the seat aswell tilt the tank back remove air box and remove coils and get a spark plug socket and insert in the heads and unscrew the plug done if you want more info get back to me

Sep 29, 2009 | 2001 kawasaki ZX-6R Ninja

1 Answer

How do i change the air filter on a 2008 kawasaki ninja 650 r

Remove front seat. Remove tank. Open airbox and slide the filter out of its groove.

Sep 08, 2009 | 2008 kawasaki Ninja 250R

1 Answer

Remove a kawasaki zx9r petrol tank

Take riders seat off, undo small bolt in front of take. Will now lift up on rear hinge. Remove long bolt from rear hinge, remove fuel pipes and lift off.

Aug 10, 2009 | 1999 kawasaki ZX-9R Ninja

1 Answer

2004 kawasaki 636zx6r ninja

remove the seat batt is hiding right there, make a short lead with a plug female on the end that will hook to your batt, make another lead with coresponding plug male (male female)to hook to charger and you will never have a dead battery agin when done riding plug up the trickle charger PS make the lead under the seat long enough that it will hang out so you dont have to remove seat everytime

Dec 29, 2008 | 1997 kawasaki ZX-6R Ninja

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides