Question about Suzuki Motorcycles

Open Question

My gsx-r 1000 2007 fuel light came on stay on, even when the tank is full.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 190 Answers

SOURCE: fuel light stays on 02 gsxr 1000

check for open wire on the harness going to

color/stripe

4 wires fuel pump & level wires
yellow/red,black/white are pump wires black/lightgreen,black/white


3 wires Fuel resistor module wire colors blue/Lightgreen,orange/green,red/black

o1 manual

3398c15.jpg

Posted on Apr 06, 2009

  • 219 Answers

SOURCE: BMW X5 fuel guage doesn't register

hi will, it sounds like one or both of the fuel sending units has failed. the sender on the passenger side is responsible for reading empty to 1/2 tank, and the one on the driver's reads 1/2 to full. if the passenger sender is stuck down or failed, it could read empty when the tank is full. the senders are a pain to install correctly due to the installation angle. I have even seen techs at the dealer install them and have to reinstall them. i would recommend having both of the senders tested.

Posted on Apr 09, 2009

CMV9
  • 594 Answers

SOURCE: gas gauge reading empty even when tank is full

Usually if the gas gage does not work yes it is true it may be the sensor if it is electronicly controlled. the sncor will more than likley be in the tank. here is how to remove your gas tank.

  1. Before servicing the vehicle, refer to the precautions section.
  2. Relieve fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:
    • Negative battery cable
    • Fuel filler and vent hoses
    • Fuel tank skid plate
    • Fuel tank wiring connectors
    • Fuel supply and return lines
    • Fuel tank
    • Fuel pump assembly
      7924bg17.gif Fuel pump assembly mounting
To install:
  1. Install or connect the following:
    • Fuel pump assembly
    • Fuel tank. Tighten the bolts to 27 ft. lbs. (36 Nm).
    • Fuel supply and return lines
    • Fuel tank wiring connectors
    • Fuel tank skid plate
    • Fuel filler and vent hoses
    • Negative battery cable
  2. Start the engine and check for leaks.

Posted on Apr 16, 2009

  • 1 Answer

SOURCE: low fuel light flashes even when tank is full of

was the tank off the bike recently?  was the fuel sensor plugged back in?  its the wires at the rear of the tank.  i fixed one like this for a customer recently.

Posted on May 21, 2009

  • 3567 Answers

SOURCE: 2008 suzuki GSX 1000 motorcycle indicates on

FI = Fuel Injection. The FI computer is telling you that it has detected a problem and the code for that problem is "C13". Telephone your dealer and ask what that code C13 indicates is wrong. Then you can determine if you want to try the fix, i.e. "clean the air filter", or if the shop must do it, i.e. "# 3 injector is restricted".

A “very helpful” rating for this answer? Thanks!

Posted on Jun 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 chrysler new yorker. Fuel gage doesn't register. Low fuel light stays on even when tank is full.


More than likely the sending unit is not communicating with the fuel gauge so even when the tank is full the unit doesn't register it.There could be a short or a loose connection from the sending unit to the guage

Jul 13, 2015 | Chrysler Cars & Trucks

1 Answer

Hi I have problems with my mitsubishi dehumidifier Oasis Elite MJ-E-142NX-A1 The water tank full light stays on even though the tank is empty. I have emptied the water and replaced the container care


Sounds like your float is stuck in the full position, or the sensor that shows full is stuck on full.
If tank is empty but shows full, problem lies where full signal is coming from.

Aug 19, 2014 | Dehumidifiers

1 Answer

Warning light for low fuel stays on


The sensor is part of the fuel pump module inside the gas tank.
The signal is sent to the body computer, so it could be a faulty module or a problem with the body computer.
The circuit would need to be checked with a meter.

Feb 08, 2013 | Volkswagen Cars & Trucks

1 Answer

Why does my fuel gauge stay on when I have a full tank of gas?


Your ECU could be fouling up, Could have a short or ground, gas sending unit could be malfunctioning, Autozone can put a ECU checker on your system and it should indicate possible causes

May 02, 2012 | 2004 Nissan Maxima

1 Answer

On 2002 acura 3.5rl fuel light stays on


you fuel censer could be bad!

Feb 14, 2012 | 2002 Acura 3.5RL

1 Answer

I have a 2004 pontiac montana. for about two years the fuel guage would fold over and read 125 degrees when the tank is full. it woulld stay there until tank was empty and the needle would drop to empty,...


It could be a bad fuel gauge in the dash unit, but....
Usually it's "The bad".
The fuel level sending wipe arm and windings on the fuel sender wear and send erratic readings.The only cure is a replacement fuel gauge sender.
The check engine light should not be related to the erratic fuel readings.
"The good".
If you have over 200,000kms or 120,000 miles on your van you need a new fuel pump anyway,so have a complete assembly put in which will have a new fuel sender on it.

May 21, 2017 | 2004 Pontiac Montana

1 Answer

The low fuel light stays on even when tank is


Hi: Your Fuel Level Sending Unit That Is Located in Your Fuel Tank Is Probally Bad. BUT before you go to taking the Sending Unit out Of your Tank Check to see if ALL Connections To And From Tank to Gauge are Conected Good. Also You could have a Fuse that Goes to the Sending Unit,in Your Fuse Block.Check And See if You Have A Fuse Labeled Fuel Sending Unit or Fuel Sensor. If you end up Replacing The Fuel Tank Sending Unit Run Your Gas Tank Down To Almost Out Of Gas Before You Start to Remove The Metal Straps Holding Your Tank Up. Cause The Sending Unit Is on Top of Your Tank ,And Your Fuel Pump Is In The Gas Tank As Well. Hope This Has Helped You Please Send Me a Vote on How my Solutions Have Helped You And Also You Can Send Me A Testamony Thank You From the WYOCWBOY

May 31, 2010 | 2005 Chevrolet Impala

2 Answers

Even with a full tank my 2005 Envoy XUV fuel light stays on and fuel gauge marks empty


u need to change this gauge or try to dissasseble and clean it very well then try to install it back again

Jun 06, 2009 | 2005 GMC Envoy Xl

2 Answers

Gas gauge reading empty even when tank is full


Usually if the gas gage does not work yes it is true it may be the sensor if it is electronicly controlled. the sncor will more than likley be in the tank. here is how to remove your gas tank.

  1. Before servicing the vehicle, refer to the precautions section.
  2. Relieve fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:
    • Negative battery cable
    • Fuel filler and vent hoses
    • Fuel tank skid plate
    • Fuel tank wiring connectors
    • Fuel supply and return lines
    • Fuel tank
    • Fuel pump assembly
      7924bg17.gif Fuel pump assembly mounting
To install:
  1. Install or connect the following:
    • Fuel pump assembly
    • Fuel tank. Tighten the bolts to 27 ft. lbs. (36 Nm).
    • Fuel supply and return lines
    • Fuel tank wiring connectors
    • Fuel tank skid plate
    • Fuel filler and vent hoses
    • Negative battery cable
  2. Start the engine and check for leaks.

Apr 16, 2009 | 2002 Isuzu Axiom

1 Answer

BMW X5 fuel guage doesn't register


hi will, it sounds like one or both of the fuel sending units has failed. the sender on the passenger side is responsible for reading empty to 1/2 tank, and the one on the driver's reads 1/2 to full. if the passenger sender is stuck down or failed, it could read empty when the tank is full. the senders are a pain to install correctly due to the installation angle. I have even seen techs at the dealer install them and have to reinstall them. i would recommend having both of the senders tested.

Apr 07, 2009 | TMI Products VizuaLogic 90A-79006-L563 BMW...

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Ed Nelson
Ed Nelson

Level 2 Expert

149 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...