Question about 2010 Harley Davidson FLHX Street Glide

1 Answer

Remove hd dash street glide - 2010 Harley Davidson FLHX Street Glide

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Harley Davidson Master
  • 43,738 Answers

Hi Anonymous, for more information about your question please visit the website below. Good luck and have nice day.
Electra Glide Ultra Classic Harley Davidson Maintenance Tip Fairing Removal

Posted on Jun 08, 2015


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 119 Answers

SOURCE: torque settings on 2006 street glide

the clutch(derby) cover torque is 96 in lbs
the trans side cover is 120 in lbs.

Posted on Mar 31, 2009

  • 1 Answer

SOURCE: 2007 street glide misses and wonts to stall out when taking off??

my roadking just did the same thing, check the gasket between carb and intake

Posted on Aug 10, 2009

  • 13 Answers

SOURCE: Set the time on a HD Street Glide

sets itself

Posted on Oct 09, 2009

  • 63 Answers

SOURCE: 2008 FLHX Street Glide: no problem, just asking what DOT # of brake fluid ...

DOT 4 brake fluid

Posted on Aug 10, 2010

  • 4565 Answers

SOURCE: i need to change the rear brake pads on my hd

To change the pads on your bike, look at the caliper and you'll see two bolts that hold it into the caliper bracket. Remove these two bolts. Rock the caliper in towards the wheel and back out a few times to loosen everything up and carefully remove the caliper from the bracket without disturning the pads or the anti-rattle hardware.

Take special note of how the anti-rattle hardware is positioned in the caliper bracket. Now, replace the pads and hardware with new parts. Make sure you install the inside pad with the fiber side towards the rotor. Don't laugh, you'd be surprised at how many I've seen installed backwards.

Now, next you must get the piston pressed back into it's bore. I use either a large C-clamp or a large pair of slip joint pliers to press the piston back into it's bore. Use rags or thin pieces of wood to protect the finish on your caliper. Once you get the piston all the way back down in the bore, carefully slide it back down over the pads without disturbing them. Replace the two screws and torque them to 35-40 foot pounds.

Slowly depress the rear brake pedal until you get a nice firm brake pedal. Make sure you test the brakes before you ride the bike at any high speeds. Failure to test the brakes for proper operation can cause severe injury or death.

Good Luck.

Posted on Aug 16, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Solenoid stinking on my HD street Glide

Possible reasons:

Bad starter relay
Bad solenoid

Was the right handlebar switch housing opened before this started?
The starter button wire might have been pinched when reassembling, and it finally wore the insulation to the point where now it's grounding out.

The starter switch itself could have gone bad.

Mar 23, 2014 | Harley Davidson FLHX Street Glide...

1 Answer

How much oil does a 2006 street glide hold

Hi Anonymous, oil capacities on touring models:
1. Engine oil 4 qts. with filter Hd Multi Grade 20w50.
2. Transmission oil 20-24 oz HD Transmission Lubricant.
3. Primary oil 32 oz. HD Primary Chaincase Lubricant.
Have a nice day.

Mar 29, 2013 | 2006 Harley Davidson FLHX Street Glide

1 Answer

Need spark plug gap for flhx street glide

Hi Anonymous, the HD 6R12 spark plug is gapped at .040" Have nice day.

Apr 24, 2012 | 2007 Harley Davidson FLHX Street Glide

1 Answer


Id try another dealer....good luck or change out the part in hand grip.. also where these wires plug into harness clean conections then use a moisture sealent . hd has had problems inthis area w/ what is called fretting..

Feb 10, 2011 | 2008 Harley Davidson FLHX Street Glide

1 Answer

2008 hd street glide cruise inop switch lights up when you set no light in tach

Hi Patsullivan7, for more information about your question please visit the website below. Good luck and have nice day. Controls and Indicators

Jun 24, 2010 | 2008 Harley Davidson FLHX Street Glide

1 Answer

My check engine light goes on sometimes and then goes back off or stays on till I shut it down and restart it. What is the sequence that will show me the erroe code? I have a HD 2008 Street Glide

on your dash is the button to check your milage. push it in and hold it down until your codes come up. some of the numbers it will go through will only be ecm numbers

Oct 09, 2009 | 2008 Harley Davidson FLHX Street Glide

Not finding what you are looking for?
2010 Harley Davidson FLHX Street Glide Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4536 Answers


Level 3 Expert

4340 Answers


Level 3 Expert

76846 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides