Question about Motorcycles
Could you have a flat battery by any chance or the main power cable to the starter motor could be broke or damaged in some way ,by the battery are two fuses and this i have had problems with on my gilera as they seem to corrode being in such close proximity to the battery
Posted on Feb 10, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: gilera runner 50cc wont start
Don't do the gas down the spark plug thing. It's a bad idea. Do the following >
Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash in the bowl? Drain a cup of gas from the tank. Is there any water or trash in the cup? Dump it, clean it and re-mount it, ( not all bikes have a water trap bowl ).
Drain the carburetor. There should be a screw on the lower side or bottom of the carb float bowl. Remove the screw then replace it after the fuel drains. Turn the gas back on and wait a minute for the carb to fill with gas. Install a new stock NGK spark plug and try to start the engine. If the bike doesn't start and run properly then shut off the gas and remove the carburetor from the engine.
Remove the float bowl and clean the entire carb with a spray carb cleaner from the auto parts store. Wear protective goggles to avoid getting spray in your eyes. Spray into all the little airways and fittings in the carb. Remove the idle screw and the air screw on the outside throat of the carb and spray into the screw holes as well.
< < READ CLOSELY > >
Be sure to put these two screws back in the same hole they came out of. IMPORTANT > do not tighten these two adjusters down. Only screw these in until they LIGHTLY seat. Now turn each adjuster one and one half turns outward. Put the rest of the carb back together, clean the air filter and install the carb. Let the float bowl fill then start the engine. This process should get you back on the road.
Please rate this solution. Thanks!
Posted on May 25, 2009
yes it has a chip in the master key (the bigger chunky key)..& this is all linked with the cdi uint code....there should be a light flashing on the dash when the scooter is not running..that means the immobiliser is armed
Posted on Jan 26, 2010
Tips for a great answer:
Oct 21, 2013 | 2005 Gilera Runner VX 125
Oct 15, 2011 | 2005 Gilera Runner VX 125
May 11, 2010 | 2005 Gilera Runner VX 125
Apr 08, 2010 | 2005 Gilera Runner VX 125
Feb 06, 2010 | 2005 Gilera Runner VX 125
Jan 25, 2010 | 2005 Gilera Runner VX 125
Nov 16, 2009 | 2005 Gilera Runner VX 125
Mar 10, 2009 | 2005 Gilera Runner VX 125
Sep 25, 2017 | Yamaha Motorcycles
229 people viewed this question
Usually answered in minutes!