Question about Motorcycles

Open Question

2000 yamaha bigbear 400 4x4 no spark - Motorcycles

Posted by on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3567 Answers

SOURCE: yamaha big bear no spark

I'm not familiar with all quads and all the kill switch locations. Does it have a tip-over kill switch? Is it working? Is the quad in neutral? Is the neutral light on? Many engines will not spark if the neutral light is not on. Are the headlights off when starting?

How good is your battery? A low battery can kill spark. Test for spark by grounding the threads of the plug against the cylinder. Have a friend kick the bike while you watch for spark. Assuming no spark, then check all the kill switches with an Ohmmeter to be sure each switch is working properly. Sometimes a switch goes bad. Try disconnecting all kill switches then check spark.

Check the wiring harness, even under the gas tank and seat. Are all the connectors clean and with a tight connection? Any abraded wires? Check the ignition switch also. The switch can go bad as well. Are the flywheel coils good > is the battery getting a charge?

Still no spark? If CDI then get it checked.
If points then file or replace them along with a new condensor and reset the gap then time the engine. >> I hope this helps.

Please rate this answer. Thanks trsrhntr!

Posted on Apr 03, 2009

  • 89 Answers

SOURCE: Won't Start

do you have compression? for a engine to run you need clean air,compression, good fuel(make sure the fuel has not been there 3 months or more as it will deteriate) and good spark as well as good exhaust as this will cause a back fire if the exhaust valves are not set right.

Posted on Apr 21, 2009

DoubleClutch
  • 376 Answers

SOURCE: I have a 2000 Yamaha Wolverine that over the past

Check the battery and make shure it is fully charged. Check the coils to see if they have went bad. You can have them tested at any repair shop. Last the CDI could have went bad.

Posted on Sep 17, 2009

  • 245 Answers

SOURCE: need operating manual for 1997 yamaha blackbear

Here is a location for the Service Manual. Maybe the operating manual
is available there too. Goodluck!
http://www.yamaha-motor-europe.com/community/service/manuals.jsp

Posted on Nov 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the spark plug gap on a 2000 Yamaha V-Max


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
Spark plug gap VMaxForum net
Max Tech
http://www.journey.cz/moto/navody/Yamahal-Vmax.pdf
OEM parts for Yamaha
YAMAHA VMAX VMX12V Owner Manual

Sep 29, 2014 | 2000 Yamaha V-Max

1 Answer

I need to change spark plugs on Yamaha virago 535


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
YAMAHA XV535 Owner Manual Spark Plugs
Yamaha Virago 750 changing your spark plugs
Yamaha XV 535 DX Virago Service Manual
OEM parts for Yamaha
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-16_110.pdf

Feb 06, 2014 | 1994 Yamaha XV 535 Virago DX

1 Answer

Spark plug change


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.starmotorcycles.com/assets/service/manuals/2000/LIT-11626-13-16_110.pdf
OEM parts for Yamaha
Yamaha XV 535 DX Virago Service Manual
Yamaha Virago 750 changing your spark plugs
YAMAHA XV535 Owner Manual Spark Plugs

Feb 05, 2014 | 1994 Yamaha XV 535 Virago DX

1 Answer

I cannot find the spark plug on my 2000 razz SH50


Hi, Sharon for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere zero $ you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
2000 razz SH50 spark plug location Google Search
How to change spark plug in Yamaha Vino 50cc Scooter XC50
http://www.hondaspree.net/other/Yamaha_SH50_Razz_Service_Manual.pdf
OEM parts for Yamaha
http://joezekistan.com/documents/Yamaha_SH50_Razz_Owners_Manual.PDF

Aug 05, 2013 | Yamaha Motorcycles

1 Answer

2000 YZF R1 ONE DAY I SAW THAT BATTERY WAS SWOLLEN. REPLACED BATTERY WOULDNT START


Hi, Merle and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and CDI box.
5. Spark plug cables in bad condition, shorting / leaking, spark plug cable connections loose, check for spark leakage in the dark.
6. Faulty ignition coil, pick up coil, trigger coil or CDI box testing needs to be checked with an ohmmeter at 70 degrees Fahrenheit
7. Faulty safety switches clutch, kickstand, neutral, off/on etc.
8. Faulty ignition switch.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.r1-forum.com/forums/102-00-01-r1-mechanical-help/287594-2000-r1-wont-start-no-spark.html
http://www.r6-forum.com/forums/57-garage-mechanical-help/38102-00-r6-turns-over-but-no-spark.html
2000 2001 Yamaha YZF R1 Service Manual R1 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Aug 21, 2012 | 2000 Yamaha YZF-R1

1 Answer

My 2000 yamaha R1 has no spark. All the fuses are good and i changed the ignition box but still no spark??? HELP PLEASE


Hi, Tom and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and CDI box.
5. Spark plug cables in bad condition, shorting / leaking, spark plug cable connections loose, check for spark leakage in the dark.
6. Faulty ignition coil, pick up coil, trigger coil or CDI box testing needs to be checked with an ohmmeter at 70 degrees Fahrenheit
7. Faulty safety switches clutch, kickstand, neutral, off/on etc.
8. Faulty ignition switch.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.r1-forum.com/forums/102-00-01-r1-mechanical-help/287594-2000-r1-wont-start-no-spark.html
How to diagnose no spark situation on motorcycle
2000 2001 Yamaha YZF R1 Service Manual R1 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Apr 22, 2012 | 2000 Yamaha YZF-R1

1 Answer

Changing spark plugs on a yamaha thunderace


Hi, Anonymous for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
Thunderace Spark Plugs
How To Change Spark Plugs on Yamaha R1 R1Videos com
Yamaha YZF1000RJ Service Manual
OEM parts for Yamaha
YAMAHA YZF1000R Owner Manual

Mar 24, 2012 | 2000 Yamaha YZF Thunder ace 1000 R

1 Answer

1998 yamaha bigbear 350 - starting problem. Will start on pull cord easily but will not start when turning it over with the starter. It now has a new battery, new top end and problem still persists....


Your selonoid for your starter is most likely the problem. Find it and check the connections for corrosion and to make sure they are tight. If it still doesn't start the selonoid needs to be changed.

Mar 15, 2010 | 2003 Yamaha WR 450 F

1 Answer

Need operating manual for 1997 yamaha blackbear


Here is a location for the Service Manual. Maybe the operating manual
is available there too. Goodluck!
http://www.yamaha-motor-europe.com/community/service/manuals.jsp

Nov 17, 2009 | Yamaha RD 350 Motorcycles

1 Answer

2000 R1 won't start


Hi, Tom and the usual suspects are:
1. Fouled spark plugs.
2. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
3. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
4. Loose connection at ignition coil or plug between ignition sensor and module.
5. Spark plug cables in bad condition, shorting / leaking, spark plug cable connections loose check for spark leakage in the dark.
6. Faulty ignition coil or electronic control module.
7. Faulty CKP, CMP, or BAS sensor.
8. Faulty ignition switch.
9. Tilt sensor needs a reset.
10. Security alarm failing to disarm needs reset
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below and for more specific information or questions at no charge please feel free to contact me at xlch@mail.com. Good luck and have a nice day.
http://www.r1-forum.com/forums/102-00-01-r1-mechanical-help/287594-2000-r1-wont-start-no-spark.html
http://www.r6-forum.com/forums/57-garage-mechanical-help/38102-00-r6-turns-over-but-no-spark.html
2000 2001 Yamaha YZF R1 Service Manual R1 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Mar 02, 2009 | 2000 Yamaha YZF-R1

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

kakima

Level 3 Expert

102366 Answers

Are you a Motorcycle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...