Question about Harley Davidson FLTR-FLTRI Road Glide Motorcycles

1 Answer

My carburetors on my road glide not working - FLTR-FLTRI Road Glide Harley Davidson Motorcycles

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Rebuild them. the local shop can use an ultrasonic cleaner if you dont feel up to doing it yourself

Posted on Feb 07, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just bought a 2015 road glide with ABS brakes could I use my brembo chrome calibers off my 2009 streetglide on the road glide thanks Eddie D


Hi Eddie, 4 out of 5 Harley Gods give this one a thumbs down, but just to be on the safe side contact your local dealers parts department for confirmation. Good luck

Jan 12, 2015 | 2015 Harley Davidson Road Glide Special

1 Answer

Carburetor removal for 2000 Road Glide


Hi Anonymous, it's pretty straight forward, you might have raise or remove fuel tank to gain access. Start by turning off fuel valve, remove fuel line, air cleaner and backing plate, throttle cables, and choke cable, then just wiggle it out of the intake manifold. Good luck

Apr 20, 2014 | 2008 Harley Davidson FLHX Street Glide

1 Answer

Carburetor removal


Hi Anonymous, check answer to previous question. Good luck

Apr 20, 2014 | 2000 Harley Davidson FLTR-FLTRI Road Glide

1 Answer

Speedometer stopped working and motor keeps cutting out


Hi Anonymous, and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap to close or to wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Damaged wire or loose connections at battery terminals,
ignition coil, or plug between ignition sensor and module.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust vale.
For a prime suspect please visit website below:
How to Find your Diagnostic Trouble Codes Road Glide Forums
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley... Good luck

Jan 25, 2014 | 2011 Harley Davidson FLHX Street Glide

1 Answer

Remove inner fairing 2010 road glide


Hi Anonymous, for more information on your question please visit the websites below and good luck:
2013 Road Glide Inner Fairing Instrument Cluster Removal for Paint

Dec 01, 2013 | 2008 Harley Davidson FLTR Road Glide

1 Answer

Remove battery cvo road glide


Hi Anonymous, for more information on your question please visit the websites below and good luck:
Exposing the Wiring and the Battery on 2011 Harley Davidson Road Glide...

Nov 05, 2013 | 2011 Harley Davidson FLTRUSE CVO Road...

1 Answer

Engine cuts out going down the road


Hi Anonymous, and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap to close or to wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Damaged wire or loose connections at battery terminals especially the ground cable at BOTH ends, ignition coil, or plug between ignition sensor and module.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor or intake seals.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust valve.
For a prime suspect please visit website below and good luck:
Big Twin Carb EFI DTC Intructions codes Harley Davidson Forums Harley...

Mar 09, 2013 | 2001 Harley Davidson FLHT Electra Glide...

1 Answer

Where is the signal flasher located on a 2009 road glide


The 2009 Harley Road Glide turn signal flasher is located inside the fairing, which is under the dash board on the driver's side. To remove the turn signals from the fairing, you need to unbolt them from the socket wrench. Get additional details from http://www.ehow.com/how_5791484_remove-road-glide-fairing.html.



i dont know if this is relevent to your year but if its not there under the tank is a good second place to look

Nov 30, 2012 | 2006 Harley Davidson FXDCI Dyna Super...

1 Answer

2009 electr glide wont throttle and has problem starting


Hi Gilbert, and the usual suspects are:
1. Spark plugs in bad condition or partially fouled.
2. Spark plug cables in bad condition or leaking.
3. Spark plug gap to close or to wide.
4. Faulty ignition coil, module and or sensor.
5. Battery nearly discharged.
6. Damaged wire or loose connections at battery terminals,
ignition coil, or plug between ignition sensor and module.
7. Intermittent short circuit due to damaged wire insulation.
8. Water or dirt in fuel system, carburetor or filter.
9. Fuel tank vent system plugged or carburetor vent line closed off.
10. Carburetor controls misadjusted.
11. Damaged carburetor.
12. Loose or dirty ignition module connector at crankcase.
13. Faulty MAP, CKP, and or CMP sensors.
14. Incorrect valve timing.
15. Weak or broken valve springs.
16. Damage intake or exhaust vale.
For a prime suspect please visit website below and good luck:
Harley Diagnostic Codes 04 to Present

Jul 20, 2012 | 2002 Harley Davidson FLHTCUI Electra Glide...

1 Answer

My lighter works fine but won't charge my phone or i pod, 2009 H/D road glide


Voltage regulator will not allow enough current to the lighter to charge sophisticated electronics. Install a 12v outlet directly to the battery or re wire your lighter to connect the positive directly to the battery.

Jul 08, 2009 | 2000 Harley Davidson FLTR-FLTRI Road Glide

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

4514 Answers

Gills Lango

Level 2 Expert

195 Answers

Mike

Level 3 Expert

4336 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...