SOURCE: speedometer cable
First: you unscrew the cable housing assembly from the back of the speedomiter housing.
Second: you pull the speedomiter cable from the housing.
If the cable is broken inside the housing you must unscrew the housing from the spedomiter adaptor on the front axle,. at this point you should be able to pull the broken end from the adaptor with a pair of pliersif you can't pull it at this point you will have to pull the front axle and take the adaptor out and try to remove the broken end.
I hope this helps.
SOURCE: replace speedometer cable
First: you unscrew the cable housing assembly from the back of the speedomiter housing. Second: you pull the speedomiter cable from the housing. If the cable is broken inside the housing you must unscrew the housing from the spedomiter adaptor on the front axle,. at this point you should be able to pull the broken end from the adaptor with a pair of pliersif you can't pull it at this point you will have to pull the front axle and take the adaptor out and try to remove the broken end. I hope this helps.
SOURCE: install a baron bullet tachometer on 2003 FLHRCI
remove big 1/2" nut below speedo, and + screw lower on tank dash, then lift intire dash and youre their. dose this help?
SOURCE: oil drain plug
Hi
It is located on the right side just under the oil tank ; if you follow the rudder hose that exits the rear right side of your oil tank it leads to the bottom of the frame under this is the oil plug. This hose has a plug clamped to the end of it or stuck into a prug that is welded to the frame.
After this unclamp and pull the plug to make sure that you have the dipstick out before pulling it loose.
Please do rate the solution as "FixYa" if found useful and revert for further assistance.
Thanks
Rylee
SOURCE: removing harley davidson ultra classic gas tank
Drain the fuel either by siphening or removing the cross over tube at the front of the tank and letting it drain that way or just block off those cross over lines and leave the fule in the tank for removal.
0) remove seat
1) drain fuel
2) undo cross over line (bottom front of gas tank.
3) shut off pet **** and remove fuel line from pet ****.
4)there should only be 2 bolts holding the tank on, one at the top front of the tank and one at the back of the tank.
All in all a pretty easy (but possibloy messy) job.
529 views
Usually answered in minutes!
×