Question about Transport Schwinn Rechargeable Portable Scooter

1 Answer

Norton fireflye 50 qt-7 keep cutting out then wont start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 44 Answers

Please go ahead and uninstall and reinstall the norton because there might be conflict with the norton with the windows updates

Posted on Mar 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a gilera runner50cc 2006 sp when i am riding it it starts to cut out had a new carb fittered can anybody help please


If the new carb has more air flow and you don't change the exhaust to match it will over heat, And do what you describe

Dec 21, 2013 | 2006 Gilera Runner SP 50

1 Answer

Keeps cutting out and wont start


Try changing the solenoid switch of your starter. check your battery too... it might be time to change it depending on how old your bike is.

Nov 07, 2013 | 1995 Honda VFR 400 R NC30

1 Answer

Carburettor keeps filling with petrol and wont start


Hi, Rooneys_no1f and the usual suspects are:
1. Damaged or restricted fuel tank venting system.
2. Loose float bowl screws.
3. Damaged float bowl o-ring.
4. improper fuel level in the float bowl.
5. Worn or dirty inlet valve or seat.
6. Damaged or leaking float assembly.
7. Particle contamination in inlet fitting cavity.
For more information about your issue please visit the websites below. Good luck and have nice a day.
https://www.tradebit.com/filesharing.php/search/0/2006+aprilia+sr+50+r+factory

Mar 04, 2013 | 2006 Aprilia SR 50 R Factory

1 Answer

Engine runs but wont rev up


Hi, Sexybarryjoh and the usual suspects are:
1. Severely drained or faulty battery.
2. Faulty regulator/rectifier or high output coil.
3. Faulty power valve, solenoid or installation.
4. Clogged air filter or exhaust.
5. Cracked or incorrect float level.
6. Float needle is not seating.
7. Faulty reed valve.
For more information about your question please visit the website below. Good luck and have a nice day.
https://www.tradebit.com/filesharing.php/search/0/2006+aprilia+sr+50+r+factory

Feb 02, 2012 | 2006 Aprilia SR 50 R Factory

1 Answer

Carbi keeps flooding started fine and rode for 10 mins then cut and wont start unless i drain the carbi and turn petrol of then starts for around 10 seconds then cuts out its a peewee 50 2010 model


the float inside the carb is probably stuck in the open position...you may need to remove the carb and have an overhaul kit installed in it....if you stored the unit without draining the fuel from the tank AND the carb, then the fuel probably went bad and has become "varnished". This fuel degradation can cause the float to stick and clog up the main and idle jets

Apr 27, 2011 | Yamaha YZ 125 Motorcycles

1 Answer

Plugs keep fowling up after 50 klms on a norton commando 850 any ideas


Fouled plugs are an indication of a too rich air/fuel mixture. You need either more air (clean air filter) or less gas (adjust main jet needle position lower) or (smaller jet).

Dec 08, 2010 | Norton Commander Motorcycles

2 Answers

Direct bikes scooter wont start


you need to have some fuel in the system over night as when it is shipped it is completly dry when this is done it should start with out any problems if it still has the same problem then you will need to charge the battrie

Nov 02, 2009 | 2004 Factory bike Chrono SM 250

3 Answers

I have a gilera runner 50 sp and it wont start


Has it been laid up for months? Did you leave any gas in it untreated? You may need to boil out the gas tank . Try a carb cleaner first that you add to the gas.Check the plugs.Are they black/oily (too rich / worn ring), Tan ( correct ).they tell a lot about the condition of the engine. Good Luck

Sep 15, 2009 | 2005 Gilera Runner VX 125

1 Answer

Gilera noly starts when revved


hi mate on the carb there will be a screw get a cross head screw driver and turn this screw in a 1/4 of turns this is the idle screw which should bring the revs up a tad remember its the screw that is sticking out good luck

Jul 23, 2009 | 2005 Gilera Runner VX 125

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Transport Experts

Jim Goldsmith
Jim Goldsmith

Level 3 Expert

1869 Answers

Robin Hill
Robin Hill

Level 3 Expert

1251 Answers

aaahandy
aaahandy

Level 2 Expert

98 Answers

Are you a Transport Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...