SOURCE: wont accelarate
you didnt say if the bike sat up for a while, if it has you have stopped up carbs the bike will run with the choke on but shut off when the choke is off says no fuel going thru the low speed jets clean them by taking the float bowls off and blowing them out with high pressure air
SOURCE: will only run with full choke and absolutely no throttle.
Carbs gummed up. Need a serious cleaning or a full ruubers replacement/rebuild kit. Gas turns to gummy when left stting in the fuel bowls.
Use a couple of cans of Sea Foam.. best stuff in the world.
SOURCE: hi, I have a H plate GT 550 the bike will tick
hello m8,,u have blocked main jets and idle jets, to do this u need to remove the carbs ,,turn them upside down, and remove the casing one at a time,take out the float,becarful not to damage the shut off needle thats attached to it,, unscrew the brass lookin screw which is the jet that the needle sits in,, and will have a number stamped on it, ie jet size, take a 8mm spanner and undo the stem that the jet has come out from and poke a needle or pin in all the little holes, hold it up to the light and u should see daylight threw the holes,, clean out any brown ,rusty lookin deposits from the float bowl casings to,,,,then put back together, repeat the same to the other 3 carbs,, and put back on bike,,this will solve it,,any probs come back and ill tell yuh,, cheers
SOURCE: bike bogs for second then revs when throttling
Pull the slide out of the carb then remove the jet needle and move the clip one notch lower on the needle.
SOURCE: 2000 yzf R6 inconsistant idle under choke cuts out when punched
Yes. Sounds like main jets are blocked. Gas will start to varnish after a couple of months. This builds up over time and sticks the main jets. Go to this website and select discuss this bike.http://www.bikez.com/motorcycles/yamaha_yzf-r6_2000.php
90 views
Usually answered in minutes!
×