My brake lights dont work checked fuses not sure which fuse it might be ...tail lights work and so do hazards .. not sure where to check next

WOW ,start by looking what muffler got cought up in ,start testing for power from steering column bottom ,and yes it could be the hand set on steering wheel.

Fuse #2 10A in underhood fuse box. Also, there's a tail light relay. Check that as well

no tails is switch ,,, no brakes is switch ,, i think ,,,, but you need to trace it using a test light

Tail lights, parking lights and dash lights are all on the same circuit...I'd go to the fuse panel under the dash and check the fuse for those lights....usually referred to as accessory lighting in the owners manual and is usually a 10A fuse.

Hope this helps...

check your fuses first. Your brake light switch could be bad and your flasher.. Good Luck!!!!

Did you check the grounding of the curuits?

well u have two seprate problems the hazards and turn signals have a flasher that needs replacing if the fuse is good on the fuse box marked signals .and there is a brake light switch under the dash board near the brake pedal it has two wires on it check the wires make sure they are connected if so replace the brake light switch

short in main harness.. but first i would check all bulbs... by this i mean pull out each bulb look at base make sure the two contact on bottom base of bulb are not melted together... aslo look good inside bulb.. to make sure the two elements inside bulb are not shorted....don't forget to check the wires to the towing plug if have one

TEST FRONT RIGHT BLINKER CIRCUIT AND REPLACE THE BULB,,WITH PROPER BULB...A DOUBLE CIRCUIT BULB IN A SINGLE SOCKET WILL DO THAT ALSO A SINGLE SOCKET BULB IN A DOUBLE SOCKET HOLDER....CHECK LEFT SIDE BULB FOR ACURANCY