Just need to know how to remove the front tire on a 05 roadking

Remove brake calipers after getting it in the air and removing the tires. If there is no screw on the front rotor jusr wiggle it off. If its stuck spay penetrating oil on the studs trying to keep it on the base so it goes beind the rotor on the hub flange. Then remove it and install the same way you removed it.

Inside of each tire attached to the valve stem is the sensor that transmits the air pressure to the indicator panel. It is possible that the sensors have gone bad on the rear of the car or that for some reason they were removed when new tires were mounted on the car. The only way to check that out is to have the tires dismounted and check the transmitter on each of the rear tires.

Please have this checked out as soon as possible. Either you, a Mechanic, or an alignment shop, need to check out the front-end and all four points. Something has changed, broke, or is loose and worn out. Check: Ball-joints, wheel bearings, tie-rods, rims, lug-nuts, tires, tire balance, tire inflation, tire tread wear, alignment, U-joints, shocks, and suspension. Let me know if I can be anymore help, good luck.

YOU NEED TO CHECK THE HUBS FOR PROPER OPERATION LIFT THE FRONT END TRY TO SPIN THE TIRE U WILL KNOW BY THE AMOUNT OF FORCE IT TAKES TO ROTATE THE TIRE

It's under the bike, towards the front of the oil pan.

Front CV joint noise.

You can develop a wobble from the front tire if it's been run under inflated. I had the same problem on my Fat Boy, the tire looked OK and I thought it was out of balance but when I repaced the tire (15K miles) the it solved the problem.

Tire spoons and irons and a air tank.Thanks for asking and I hope this helps out.Please leave me 4 thumbs up.