Bulb has gone in the Tachometer dial..can you tell me how to change bulb & how difficult it is..do i have to remove all the nose panels. thank you

Right you are going to need a pair of long nosed pliers and a hacksaw a wheel brace and a jack. For health and safety an axle stand.
Crack the nearside wheel nuts jack the car and place it on an axle stand. Remove the wheel and you will see an access panel on the arch liner remove and with long nose shove your arm to the front of the car and as you put the pliers to the left there is a tab for the indicator bulb using the long nose grab the tab turn anticlockwise a quarter turn and retract the holder and bulb change for a new bulb. the hacksaw is to trim the holder down about 10mm so you can fit the bulb back in as it won't go without being trimmed down.
This is not a joke these are the instructions given by Renault. also for more Renault information here is the web address of the gods.
http://www.renaultforums.co.uk/
MEMBERSHIP IS FREE AND YOU GET THE BEST AND HONEST ADVICE.

If you try using a thin NOSE PLIER - with a n ALIGATOR MOUTH- it will be easy to pull out by unscrewing the stuck up damaged thread of the bulb. Once it i s free even with a higly pointed screwdriver it can be pushed to unscrew.
Please try this out and it will be easy to replace.

Need to change ur picture bulbs or tries to refits the bulbs.

Your going to have to completely remove the mirrors arms (slid back the black plastic, undo the two bolts holding it onto the nose fairing) and gently pull the nose fairing forward until you can reach the back of the lights, I now this sounds a stupid way of doing it, but its the only way..

The bulb number that you need is #194.
Pull off the interior trim, and you will see the sockets for the bulbs.
Thanks for selecting FixYa to answer your question.

Push the rubber boot forward from behind and the bulb glass cover should pop out from the front of the instrument panel with a little prying with your finger tip. You don't have to push it far, just enough for the cover to pop out of the lip. Then you will be able to remove the bulb. I then use needle nose pliers to remove the bulb.

it is the bulb that has blown,the bulb is in the control knod nearest the passenger,pull off the dial and you will see the bulb,it is a little pig to get to but you will reach it with long nosed pliers,this buld does all the dials......good luck ....but it is difficult to get too the bulb.....

I just replaced the bulb on my KEMS308GSS2 and it wasn't too difficult. The bulb was $36.45 delivered from A-1appliance.com.
To change the bulb first turn off the power, then remove the plastic grills above and below the microwave unit. The bottom grill comes out easily, but the upper grill has a flange which makes it difficult to reinstall unless the flange is sawed off or the control panel is partially removed. To remove the control panel open the lower oven door and remove the screw at the bottom of each trim piece. Remove the trim pieces and then the two screws securing the control panel. With the two grills removed take out the two screws below the microwave which hold it in place. carefully slide the microwave out about half way, remove the insulation pad over the bulb and replace the bulb.

Changing the bulbs can be a difficult task, involving the removal of some of the dash panel and such. Check the fuses as it is doubtful that all the bulbs have gone bad at once.

they should be reachable from under/behind the bumper