20 Most Recent
2007 Yamaha XT 660 X Questions & Answers
Engine miss & no power
You should check to see if the spark is consistent - you might have a bad coil, plug wire/boot or a timing issue. Start with the spark, then check the timing.
I have a 2007 Yamaha Grizzly 660. It was running
It sounds like you got some corrosion going on, on the ground side. I would start with the battery cables first and see if they need cleaned up, then go to the connectors and unplug them and clean if necessary and put die-electrical grease in the sockets of the connectors before plugging them back in. I am assuming that the shifter is electrically assisted if there are problems going on with it as well...this is what makes me believe that it is a bad ground due to setting maybe in a damp inviroment.
2007 Yamaha Rhino 660 dies and pops the 30amp fuse on Relay
I would carefully go over your wiring, especially any you may have disconnected during the head gasket swap, and check for a loose ground first.
If all your connections are good, then take a voltmeter to your battery, see what it's putting out. (If you can load test it, even better). Sometimes, when a battery get's messed up, it'll start overloading and put out too much power, and burn up fuses/wires.
My Yamaha xtx660 will start for 5 secs then cut
Try replaceing fuel tank filter and pull fuel lines and see if you have fuel flowing out of the tank fuel line. If you do then the carburator is plugged up pull it apart and clean it, make sure the float is not stuck, if it's fuel injected then you have other problems.
How to tighten the chain on a Yamaha xt660x
this depends on what type of chain you have on the bike, here are videos for you to check out.
http://video.google.com/videosearch?hl=tl&source=hp&q=how+to+tighten+motorcycle+chain&um=1&ie=UTF-8&ei=kE26SvvXKdKF8Qa98ZGNCg&sa=X&oi=video_result_group&ct=title&resnum=4#
http://motorcycles.about.com/od/motorcyclemaintenanc1/ss/Chain_Maint_7.htm
I was hoping to know how to chage the oil on my xt
Oil change (no filter)
Unscrew the 17mm head bolt underneath on the kick stand's side and the 13mm head bolt under the exhaust pipes (facing forward).
After draining put back on the bolts.
Torque values: 13mm bolt---12Nm
17mm bolt---30Nm
Then pour from the upper cap on the frame 2lit of the appropriate motor oil, close the cap and start the engine and leave it idle for 5 minutes.Then switch of the engine and add 800ml more oil and you are done.
Total oil capacity (without oil filter change) 2.8lit
with oil filter change 2.9lit but you need to bleed the system from the small bolt on the filter's cap after adding the first 2lit.
Oil level on the Yamaha XT 660 X
if the filter has been changed m8 ,,u need to add an extra half a litre of oil,, it wont hurt to add extra till u do see it on the indicater,,
Oil level issues
When checking the oil, get the engine warm (not hot), let is rest for about 10 minutes and then check. This will allow the oil in the engine to flow back into the resevoir.
Replacing rear axle dust cover boot on 2005 yamaha
Inner or outter?? The outter cv joint doesn't come apart. If you rip the outter boot, you need to get a new half shaft. The inner cv joint has a clip inside that you have to take out to split the joint and install a new boot. You also need boot clamp pliers to tighten the clamps or it will come back off first time you ride it.
Not finding what you are looking for?