20 Most Recent
2003 Yamaha TW 200 Questions & Answers
The bike starts only when place in nutural, and
The clutch is not releasing sufficiently, it seems.
Alternately, some bikes will not run in gear if the kick stand is down. If the switch for that is not pushed sufficiently when the stand is up, you can have this problem.
I have a 2003 Yamaha TW 200 and it starts and runs
see if there is a saftey switch on the kick stand that is probally your problem also chek the clutch cable adjustment put in gear pull the clutch and try to push it if its hard or locks up you need to adjust your clutch cable
1989 Yamaha trail way 200 no spark
Bike is 30yr. Ignition parts wear out. Spark wires wear from inside. The spark module or magnetic points cud b problm.Alsotiming may hav gottn out of wack from tightning chain-too much torque on loose internal stuf like the timing chain. Buy aclymer orhaynes shopbook
The bike ran fine last
hi.
please excuse me if i seem to be asking obvious questions.
1. have you drained the tank and put fresh fuel in, preferrably with redex or equivalent fuel additive/cleaner
2. have you checked/cleaned the air filter.
3. have you checked and cleaned the spark plugs.
4. if there is a battery, is it charged and holding charge properly.
if you can answer YES to all of the above, then please tell me the make and model of the bike so i can give more specific advice on servicing a bike after storage.
if the answer for any of the above is NO, then try them first as they are general steps for starting any vehicle after any length of time in storage. if the bike still does not run properly, then i will need the make and model of the bike as there are different procedures for different types of carburetter, and different thing again if there is fuel injection.
please feel free to ask for further advice.
My son dismantled his 1985
Hi the case breather pipe connects to the airbox.on the airbox you should see a connect coming off from it,this is where the crankcase breather pipes connects.find a natural route to this connector making sure the pipe does not snag/bend.Good luck
Your wiringwas un clear
All points to a defective key switch - not shorted, it simply no longer makes contact. Use a tester to check all wires that come ang do to the switch then check that the switch actually makes the contact when you turn the key.
Your wiringwas un clear
Hi
Check the spark, remove the spark plug from the engine head, reconnect it in the wire boot and ground the tip of the spark on the frame or the engine. While you check for spark have someone pull the recoil for you.
A new spark plug is suggested.
Let us know if you have something more to know else accept the suggestion.
Thank You for contacting Fixya.com
I have a 1984 yamaha 200e trike the ignition
got the new switch, bat feed to input of switch,ignition coil lead to first output,wire from starter solinoid to second output, so first position energizes coil,second then feeds the solinoid
Not finding what you are looking for?