20 Most Recent
1993 Suzuki DR 350 S Questions & Answers
I have dr350 when I pull the clutch lever the
Try tighten cable adjusters, check cable for damage, check the clutch release arm for damage, if thats ok its worn clutch plates replace the clutch plates and check components for damage,
How do i know that my suzuki dr 350s oil pump is
if it wasnt you would soon know it , it would seize up , open filler plug when running you will get oil flying out if its pumping do it slowly , or disconnect an oil supply pipe and kick over ,
1993 dr 350. very hard starting. how can i make
Install a new spark plug; NGK DPR9EA-9. Be sure the battery is fully charged. Drain the carb to remove any condensation in the float bowl. Use the choke and throttle sparingly to avoid flooding. Get the piston going upward to TDC compression. Now gently push the piston just past TDC so it will be heading downward. Now give the kick lever a good strong kick. Repeat the process as needed.
Help I have a dr 250s that is putting oil back
make sure it is not overfull with oil(sometimes a flooding carb can put fuel into the sump) or it may be compression blowing past the rings and pressurising the sump,
a small amount can sometimes be normal on very rough terrain
I am getting ready to replace the timing chain on
HI, QUITE A SIMPLE JOB IN THIS ENGINE, LESS COMPLICATED THAN MODERN BIKES, IF YOU ARE IN ANY WAY CONFIDENT YOU CAN DO THIS THEN JUST MAKE SURE YOU PRE ALIGN ALL THE MARKINGS ON THE CRANKSHAFT, AND CAMSHAFT BEFORE DISASEMBLY, MAKE YOURSELF A DIAGRAME, TOP DEAD CENTRE, WITH CAM LOBES FACING DOWN, YOUL HAVE NO PROBLEMS, THE ONLY TIP I WOULD GIVE YOU IS CLEANLYNESS IS INPERATIVE, CLEAN THE MATING SURFACE OF THE ROCKER COVER AND CYLINDERHEAD, USE A GOOD SEALENT , IE HAELOMAR OR SIMILAR BUT DONT USE SILICONE AS THIS PUSHES OUT WHEN YOU TIGHTEN UP THE FIXING BOLTS, 6mmBOLTS 6-8ftlbs & 8mm bolts 12-16ftlbs (6mm bolts have a 10mm bolt head & 8mm bolts have a 12mm bolt head,
Where can I find a new engine?
Yes, first check with your local bike dismantler then check the Web through Google if you can't find any in your local area else go to eBay under parts.
Chain lubricant
Most are spray mate, but I have used chainsaw oil in the past, its very good, easy to clean off if it flings and I just used to put it on the chain with an old paint brush.
Engine wont start no power
Hi, Check battrery cabbles to and from the starter. Check that alternater is charging. Check
solenoid which would be near starter. (lose connections). Good luck.
No spark
What bike do you have, and are the volts/ohms in spec? You can have continuity, but not enough juice for proper spark. cleaned the ground posts with sand paper and the put it back on. then i unplugged the kill switch and then plugged it back in. then replaced the spark plug and it started right up . so try this couple of things and see what happens. You need a mulit-meter to make sure that you are getting proper juice
I was replacing my rear
Hi,,remove the tape and check the connections,,when you say "everthing went dead i assume you mean all lights ect,,,check your fuse box,,,more than likely the indicator wiring has shorted and blown a fuse.
How to remove seat to access the battery and carb.
Hi dogothedeser,
You did not state what model Suzuki you have. Some batteries are on the underneath of the bike; seats are usually bolted on and can be removed by removing the side covers and then removing the bolts holding the seat on. The fuel tank usually has to come off too. This is usually held on by a single bolt under the seat.
If you would please post a comment with the Model of your Suzuki, I may be able to assist you quickly.
Thank you.
Cannot remove rear axle on dr 370 suzuki
Just a big nut on one end. Sounds like its frozen in, as there is a metal "tube" in the center of the wheel between the wheel bearings, and if it's never been greased, I'm sure it's rusted in. Lots of patience and spray rust solvent in, and let it sit, repeat... This may help.
Not finding what you are looking for?