20 Most Recent
2002 Hyosung GV 250 Aquila - Page 8 Questions & Answers
Gear indicator help
im not sure on the gear indicator, but your main bearing might be too tight or need lubricating. sorry its not much help
9/13/2013 12:59:39 AM •
Hyosung...
•
Answered
on Sep 13, 2013
250 fuel pump
It is possible to rebuild anything that a human has put together. The real question is, Is it worth it? You can get a service kit and rebuild it that way. But, it would depend on the reason for the failure of the pump.
6/8/2013 7:58:15 PM •
Hyosung...
•
Answered
on Jun 08, 2013
Starts runs wont accelerate
It seems there is fuel starvation when you reach that speed or the spark plug seems to fail.(1) Check the spark plug and also see if it's of a correct specs per the manufacturer's recommendation.(2) There could be a blockage in the carb's main jet which restricts the flow of fuel at that speed.Hope this helps!
5/4/2013 2:01:07 PM •
Hyosung...
•
Answered
on May 04, 2013
Rear disk brakes on motorcycle are not working
Assumeing you have been trying to bleed the brakes and assumeing you tried that because your brakes quit working. Check a couple things. First try opening the bleeder first then pushing the peddle and see if fluid moves. Next make sure the piston in the master cylinder has its full range of motion ( not a lot of slop in the pedal at rest ). If you have these symptoms then you likely need a master cylinder rebuild. If you keep losing fluid you have a leak, and if you just changed a a bunch of stuff then its start at the beginning by bleeding the master cylinder.
10/25/2012 4:53:42 AM •
Hyosung...
•
Answered
on Oct 25, 2012
Charging the battery
If you have a battery charger, remove the battery cover to expose the battery terminals then you can connect the battery charge to the battery.Make sure you connect the positive lead from the charger to the positive terminal on the battery and the negative lead from the charger to the negative terminal on the battery before you power up the battery charger.When you have finished charging the battery, power off the battery charger before you disconnect the leads from the battery.
7/4/2012 7:49:57 AM •
Hyosung...
•
Answered
on Jul 04, 2012
What is the length of lift cables on a 1993 model 2693 hilo camper and any info on what after market part to use ? thanks
The lift cables on a 1993 model 2693 Hilo camper are 30 feet,2 3/4 inches long and fit the standard height lift of 11 feet 8 inches high to the top of the overhead. The lift uses two cables. According to a Hi- Lo camper travel trailer forum, cable replacement is basically the same on all years and models, with the main difference being the length of the cables from model to model. You can use a cable cut chart to find what cable length you need for your camper, and you'll need to know your year, model name, and box (body) length: Lift cables typically wear out after three to five years, so it's important to replace them as needed and keep them regularly maintained.
4/12/2024 1:26:15 AM •
Motorcycles
•
Answered
on Apr 12, 2024
Were do the fuel lines go to on a mountop 150cc
This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank.
Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor.
The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator.
2/28/2024 4:42:51 PM •
Motorcycles
•
Answered
on Feb 28, 2024
Not finding what you are looking for?