20 Most Recent
2008 HM CRE F250X Questions & Answers
Tire
Medium Hard Pack).
Thanks!In general you tyre pressure should vary between 12 - 16psi depending on ground condition's. The softer the terrain is the less pressure you put in your tyres, for example, muddy condition's would require a tyre pressure of about 12 - 13psi, hard pack would require about 13 - 15psi and even a little harder if its rocky. You have to be careful on rocky surfaces though because the harder your tyre the more the rocks will have a marble effect on you.
If you don't want to be messing around with tyre pressures all the time and want a happy medium, I would suggest running 13psi.,,,
Fork
loosen top pinch bolts loosen caps remove forks remove springs , fill according to manual level . re-instal everything .,,,
Throttel sticking
reeds and so forth. Then drained all the gas out. My throttle is somewhat sticking or not springing back quickly when I turn it. Is this do to the fact that it needs gas back in it to lube itor maybe just needs to be warmed up more? It was 40 deg F today. I haven't put gas in it because I am waiting for winter to end. Also When I add the gas back in the tank is there anything special I need to do before I try and start it? Like pump the throttle a few times or something. ,had the same problem. I popped of the the actuall throttle grip and under it was some caked in sticky stuff. Clean it off added a little lube and its good to go.,,,
Trying to set my sag
97 cr250 came with a yellow spring stock 5.3. You need to drop down in rate. Run a 5.2. That rate ranges for a rider between 165 to 180
Were do the fuel lines go to on a mountop 150cc
This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank.
Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor.
The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator.
2/28/2024 4:42:51 PM •
Motorcycles
•
Answered
on Feb 28, 2024
Cleaned my carburetors and the Jets and now my bike won't start. I have a spark but it won't start.
All questions need FULL 'year make model', as the first 3 words.
Then there are 10,000 categories listed by 'make year model'.
So we are working blind.
Make sure gasoline is being delivered to the carbs by removing the fuel delivery pipe.
Carbs come in different systems. If it has a float bowl on the bottom, tap it with the handle of a screwdriver as it may be stuck.
Turn the engine over. If it doesn't start, remove the spark plug and see if it is wet with gas?
You need three things for an engine to start
Clean gas
A spark at the right time
Compression
You have one thing missing
//
2/21/2024 6:59:48 PM •
Motorcycles
•
Answered
on Feb 21, 2024
How do I reset 2007 Victory Vegas 8 ball petrol sensor please.
To reset you need to follow this steps below
1.Turn the ignition switch to the "On"position
2.press and hold the trip reset button on the dashboard until the fuel gauge reset or blinks
3.Release the trip reset button
4.Start the engine and let it run for a few minutes to allow the sensor to recalibrate
5.Turn the engine off and then restart it to ensure the reset was successful
2/8/2024 6:39:37 AM •
Motorcycles
•
Answered
on Feb 08, 2024
Not finding what you are looking for?