20 Most Recent
2000 Gas Gas Pampera 125 Questions & Answers
I have a 110cc chinesse built atv. i got gas in
These engines are based on the awesome Honda design. Unfortunately, they do not have the same quality. If you verify there is fuel getting to the cylinder and there is also spark, you need to verify compression. One of the tendencies of these engines is the valves will actually tighten as they wear in. This can cause the valves to open prematurely which causes all kinds of starting issues. Check you compression and run a leak-down check to see what the compression portion of your engine looks like.
If you need to adjust your valves, do this with the engine cold and spark plug out.
- Remove the valve caps (I believe these are 17mm and they are located on top and bottom of the cylinder head.) There may be a little oil come out of the lower (exhaust) cap.
- Remove the left side cover. This is left side if you are riding the bike. This is the stator side and there should be no oil in this part of the engine. This will also allow you to turn the engine and align the piston with top dead center.
- Rotate the engine counter clockwise until the alignment marks, sometimes indicated by a "T" are aligned with the mark on the case. If both valves are closed, you should be at top dead center. If they are not, make one more rotation.
- Use a feeler guage to check clearance between top of valve and rocker arm.
- I believe you will need to use a 10mm wrench to loosen the adjuster lock on the rocker arm. Once loosened, the adjuster will screw up or down as needed.
- If needed, adjust the intake valve to:.05-.09mm and the exhaust valve to: .11-.15mm.
- Once adjusted reverse the process.
If your valves are good to go and you are still having this problem. Remove the flywheel and verify the alignment key has not sheared on the crankshaft. The ignition timing on these Chinese engines is not adjustable, but can be off significantly if this key is sheared. I hope this is somewhat helpful.
Brake dust removal
long-armed brush is usually the best way scrub off brake dust and dirt. Apply a wheel cleaner first and let it settle before scrubbing it off. Chrome wheels will require specific cleaners so be aware of your wheel's finish before purchasing a cleaner.
Don't use tire dressing products as their glossy finishes can compromise grip,,
There is a very slim chance that anyone will know
OK just using logic, no specialist knowledge but...
If temperature fluctuates, then it sounds more like a thermostat/heat control problem. If it CAN get hot then doubtless there is gas available... It's probably something to do with the heat controller unit - can you get it checked? have you looked inside the unit to see if there is any obvious issues?
5/2/2017 6:51:43 PM •
Gas Gas...
•
Answered
on May 02, 2017
My bike will start and idle but dies when you give it gas
Kerry, Check for vacuum leaks, check the fuel line is not old and collapsing (they can look good on the outside and inner collapsed), if it ha a vented cap make sure it is not plugged.Were the floats set correctly or could be sticking. There still is a chance dirt has been re introduced into jets to. Good luck.
4/6/2016 12:44:45 PM •
Gas Gas...
•
Answered
on Apr 06, 2016
Kick start seized
IF YOUR KICKSTART HAS SEIZED AND IT WON'T TILT BACK IN THE PROBLEMS ON THE SHAFT (REMOVE THE DOMED ALAN CAP BOLT THEN REMOVE THE ACTUAL KICKSTART AND CLEAN UP THE SHAFT AND INSIDE DIA OF THE KICKSTART AND LUBE IT BEFORE REFITTING, MIND YOU DON'T LOSE THE SPRING AND BALL). IF ITS SEIZES WHEN YOU KICK THE KICKSTART THEN ITS THE KICKSTART GEAR OR BUSH IN THE SIDE COVER THATS THE PROBLEM. ITS EASY ENOUGH TO CHANGE IF YOU HAVE THE TOOLS FOR THE JOB. IF ITS A DIRT BIKE TRY TO PRESSURE WASH IT THEN SPRAY WITH WD-40 IT MIGHT HELP. GOOD LUCK IF YOU NEED HELP WITH STRIPPING IT DOWN JUST LET ME KNOW (ALSO LET ME KNOW IF ITS A LEFT OR RIGHT SIDE KICKSTART)
1/5/2014 2:26:37 PM •
Gas Gas...
•
Answered
on Jan 05, 2014
Bad pistons
yes you can but you must change the rings coz if normal the liner is chrome or coated they are different !! P...
12/16/2013 6:56:50 PM •
Gas Gas...
•
Answered
on Dec 16, 2013
Not finding what you are looking for?