20 Most Recent 2010 Kymco People S 200 Questions & Answers

Hi, Scott and the usual suspects are:
1. Throttle cables improperly adjusted.
2. Idle screw set too low.
3. Faulty air control valve.
4. Faulty stepper motor.
5. Faulty WAX unit.
6. Faulty MAP sensor.
7. Faulty ECU.
8. Clogged charcoal canister.
9. Fuel pressure too low.
10. Leaking intake rubber hoses between the throttle valve housing and cylinder head.
11. Throttle valves not correctly synced.
12. Throttle position sensor (TPS) not correctly adjusted.
13. Valve clearances are too tight.
14. Low compression.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Scooter Troubleshooting Scooter Dying Out When You Come to Stop Low Idle
KYMCO PEOPLE 125 Service Manual
Kymco Scooter Parts ATVs Scooter Parts Performance Scooter Parts...

2010 Kymco... | Answered on Jul 12, 2019

Hi, Tim and the usual suspects are:
1. Fouled spark plug.
2. Fuel injector stuck open.
3. Carburetor float needle valve, not seating.
4. Carburetor float stuck open.
5. Exhaust valve stuck open.
6. Exhaust valve bent.
7. Fuel valve leaking back through the vacuum line.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
KYMCO PEOPLE 125 Service Manual

2010 Kymco... | Answered on Jul 10, 2019

Hi, Dave the following applies to carbureted also fuel injected models and the usual suspects are:
1. Severely discharged or a damaged battery, should have 12.5 volts or better and be able to pass a load test if necessary.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Air/fuel mixture screw improperly adjusted.
10. Accelerator pump damaged or not working.
11. Water or dirt in the fuel system, carburetor or filter.
12. Restricted, blocked or kinked fuel line.
13. Fuel tank empty.
14. The gas cap is not venting properly or fuel tank venting system blocked.
15. A failed fuel pump, pressure regulator and or fuel injectors.
16. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
17. Needle and seat stuck closed in the float bowl.
For more information about your issue and valuable "FREE" downloads that you need please click on the links below. Good luck and have a nice day.
s200 stalls after 5 10 minutes
GY6 stalls immediately after starting
problems with my Kymco 200 People

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

2010 Kymco... | Answered on Jun 15, 2016

check your fuses as well as connections to your coil check your on off switch for power. use a test light for these tests it has to be electrical source related

Kymco People S... | Answered on Sep 04, 2012

The carburetor is gummed up a bit from petrol evaporating over the past year. Remove the carb and then the float bowl on the bottom of the carb and then clean the carb with spray carb cleaner. Pay extra attention to the float needle area. A generic diagram is below. Please rate my answer. Thanks. tombones49_56.gif

Kymco People S... | Answered on Apr 06, 2011

The battery may be drained. This is both true for kick start and those with a starter motor. See if you can jump start the bike when you push it and put it in gear. If it starts it is a battery issue.

Kymco People S... | Answered on Apr 05, 2011

You can buy a thread tap at most any good auto parts store or hardware / tool store. The tap will re-thread the existing threads. Bear in mind that if the hole has been stripped out really bad, the integrity of the re-thread is questionable. Having a local machine shop do the re-tap is advised. Alternate to that is just buying a new cylinder head. Please rate my answer. Thanks!

Kymco People S... | Answered on Mar 26, 2011

Wneh you fit new rings be sure to scour the cylinder bore with a rotary wire brush in the chuck of an electric drill, otherwise the rings won't seat correctly and it may burn oil and lose compression.
Treat as a new engine and run the rings in.

Kymco People S... | Answered on Mar 04, 2011

It should be the negative side of the battery or the frame.
Hope that helps

Kymco People S... | Answered on Feb 17, 2011

When you kick start a motorcycle or scooter, the motor turns over much faster than your electric starter can turn it over, even with a new battery.
I saw this before with several brands of scooters and the problem was solved by making sure you have clean battery terminals, and a fully charged good battery.
Some batteries will take a full charge but cant take a load. So your battery may seem good because it has 12+ volts, but when you try to start it it drops below 10-11 volts.
Most local auto parts stores can put a load test on your battery for free. If you purchase a new one, make sure it is the one called for for your scooter.

Kymco People S... | Answered on Nov 29, 2010

There are only three things that could do this:
1. Air intake restriction
2. Fuel restriction.
3. Throttle cable slippage.

Please check the filters, the throttle cables etc.

Kymco People S... | Answered on Aug 26, 2010

If you pull the seat bucket you will be able to trace your fuel and vacume line to the petcock. You can help the process by manualy applying suction at the vac line and a shot of starting fluid in the airbox inlet should get you going.

Kymco People S... | Answered on Aug 16, 2010

At 300 miles the only thing you might want to do is check the gearbox oil level and then lube and adjust the chain. Check with the dealer on the filter type. As to what type of oil, use 10w40 motor oil in the gear box. Don't use any synthetic oils, oil marked "EC", or oil with "special" additives. Stick with the major brands; Pennzoil, Quaker State, Mobil or Shell. If in a hot area like Texas or New Mexico go with 20w50.
Please rate my answer. Thanks!

Kymco People S... | Answered on Oct 27, 2009

Yes. You'll have to find it and check

Kymco People S... | Answered on Jul 27, 2009

Hi, Anonymous the vast majority of service, parts fiche, and owners manuals on the internet are "FREE" to download and all service manuals contain wiring diagrams in the back pages. The rest usually charge a modest fee of $15 and there is a handful of obscure, rare, obsolete, and very old models that are no longer or never were available and some were never printed in English. The Indian and Philippine markets are usually in E-book format only, for these rare occasions I shall look on eBay and find the cheapest one available. Most of the manuals will cover your exact make, model, and year otherwise one will be provided that comes as close as possible to your bike and will have most of the same info that an exact manual would have. If there is no $ sign after the manual link it is free to download.
To download your manual for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Genuine Kymco spare parts
Owner Manuals KYMCO

Kymco... | Answered on Jun 25, 2019

what is kymco...we r answering world vise questions... i don't know this name tel me is this a car or a bike or any ales...

Kymco... | Answered on May 16, 2019

Hi, Steven for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kymco, despair not, for a mere $30 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.repairmanual.com/product/cyclepedia-kymco-compagno-110i-scooter-printed-service-manual $30

Kymco... | Answered on May 08, 2019


Kymco... | Answered on Apr 26, 2019

Not finding what you are looking for?
2010 Kymco People S 200 Logo

4 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Kymco Experts


Level 3 Expert

85108 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

5914 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

People S 200 Kymco

  • People S 200 Kymco

Most Popular Question

brand new 2010 kymco people s 200

  • Motorcycles