Question about 1994 Buick Century

1 Answer

Changing the head gaskets

My head gaskets blew on my buick and i need to know how to beable to take apart the car and put it back together right. can anyone help

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,263 Answers

Your best bet is go to Napa or Oreillys and get a manual for 20 bucks. it has all the torque specs in it. it has step by step directions with diagrams and schematics. it will tell you what tools you need as well.............rate this

Posted on Sep 02, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

1989 chevy blazer ran fine blew head gasket fixed the head gasket put it back together and now it's not getting any spark

all cylinders dead, no spark on all cylinders, or just one.
did you put the distributor back right, with firing older and method
shown in the FSM>?
Dizzy plugged in (low voltage side)
check all fuses.
no spark at actual coil?

Jun 30, 2014 | Cars & Trucks

1 Answer

1986 Chevy blazer blew head gasket took it apart and fixed the head gasket put it back together now there is no spark

plug the connector bad.
step one in the FSM,

Jun 30, 2014 | Cars & Trucks

1 Answer

I have a 2002 4WD Blazer. I just replaced tthe head gaskets and now have a bad coolant lea, Fuel leak, and it wont turn over

Unfortunately it sounds like the head gasket/s were not torqued down correctly with new stretch bolts. Sorry but it requires stripping down again and sorting out.

Mar 19, 2014 | 1998 Chevrolet Blazer

1 Answer

Do i need to have my 2004 dodge intrepid anti theft code reset through a dealership if the heads and head gaskets were replaced? the entire top of the engine ws taken apart adn put abcl together.

i would disconnect the battery. removing both the positive and negative battery terminals. with both ends disconnected, hold the two terminals together for about 10 seconds. this will proform a hard reset on most chrysler vehicles. also, if this doesnt work, try turning the key to the on position, and then proforming the hard reset procedure.

Nov 04, 2012 | Dodge Cars & Trucks

2 Answers

What are the cylinder head torque specs for a 1999 cadillac deville 4.6l

I can help you with this but I have to ask one question. Have you already taken this apart and putting it back together? Did you rethread all the head bolt holes because they strip out when you tighten them and you will ruin the head gaskets. Let me know, I have don't this job quite a few times. I'll have to look up the actual torque specs. Also you are wanting the spec for the cylinder head bolts and not the cylinder head cover bolts right?

Jun 12, 2010 | 1999 Cadillac DeVille

2 Answers

The heat has went out and the engine is overheating,it blew the radiator hose off when it happened.

Sounds like you have a bad head gasket, Some simple tests at a repair shop can verify this.

No use putting any money into this until you verify the integraty of the engine

Feb 06, 2010 | 1991 Oldsmobile Cutlass Ciera

2 Answers

My uncle replaced the blown head gasket but now he doesn't have time to put back the parts he took off the car to replace the blown head gasket and my fiance's dad is willing to put it back together but he...

hard to say how far your uncle has gone with it, the best advice I can give is shoot down to a parts store and buy a $15 mechanics manual for it, this will give you pics and instructions, you can be confident then too. All the best.

Dec 17, 2009 | 1993 Chevrolet Cavalier

Not finding what you are looking for?
1994 Buick Century Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides