Question about 1992 Honda Prelude

1 Answer

Clutch mess up

We changed clutches in our 92 prelude now its hard to put in 1st gear and reverse what happened

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Le dejaron mal acomodada el clutch necesitas revisar la transmision y el cluth

Posted on Sep 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have a 2001 elantra. What would make it stay in reverse and 1st gear.it is a manual transmission


when you put it in reverse,first thing you feel a spring.after tthat you lift,
a security plate,this plate prevent you from going reverse into 1 gear.
cause the axel turn a little further when you allreddy has stop the car.
this takes two sec.thats why when putting it in reverse after you feel the spring you wait two seconds,then puch al the way in reverse.

Jul 26, 2014 | 2001 Hyundai Elantra

1 Answer

1986 F250 manual 4 speed tranny. replaced slave and master. still same problem have clutch all the way to the floor to change gears and some times still not enough to change gears. its only in 1st and...


yes it sounds like the clutch is worn.1st thing when a cutch wears is its hard to get in reverse
as long as all air is bleed out(pedal feels normal)not a bad job unless its 4 wheel drive
good luck

Jun 12, 2011 | 1986 Ford F 250

1 Answer

Audi A3 2.0 tdi sport(2005 "55") Clutch/1st & reverse gear


sounds like a bent tooth on a syncro gear in the trans

Jan 23, 2010 | 2005 Audi A3

1 Answer

Had my clutch replaced now difficult to shift into 1st gear.


Sounds like the clutch just needs adjusting after replacing its hydraulic system.

Charlie

Oct 04, 2009 | 1992 Geo Metro

2 Answers

92 escort gear problems


sounds like the shifter is worn out, replace the bushing at the shifter and the transmission.

Aug 07, 2009 | Hyundai Motor 2002 Elantra

1 Answer

Manual transmission will not shift into any gear, even when the clutch is completely depressed. It's a hard shift to begin with and now when i have to come to a stop and say move it out of 4th gear and try...


The problem sounds like the clutch. If you put it in 1st., then start it up, does it try to move with you foot on the clutch? Does the clutch pedal feel different than normal.

Jun 24, 2009 | 1998 Ford Escort

2 Answers

Prelude 2.2 vti W reg auto automatic tiptronic gearbox slipping


Hi there. Although the Dealer has changed the oil, did they do a 'Stall Test' whilst the gearbox was cold and again when at normal running temperture? If not, that's what they must do firstly. This will identify whether you have a slipping clutch/s. The Honda autobox also includes what is known as accumulators - these control how each clutch is engaged during acceleration. For example, if you are accelerating slighly/smoothly, you want each gear to be engaged gently and smoothly, whereas, when accelerating hard, you need the gear engaged quickly and hard to aviod clutch slippage. Thus, the fact that you are experiencing a hard engagement might mean that an accumulator/s is seized. If that's the case, it will mean that the autobox will need stripping, cleaning and be checked for worn components. Hope this helps, Scottech.

Apr 21, 2009 | 2000 Honda Prelude

1 Answer

My 92 honda accord will not go into 1st 3rd or 5th gear


check shift fork adjustment. make sure you bleed the slave cylinder.also check shift cable adjustment.

Apr 11, 2009 | 1992 Honda Accord

1 Answer

Transmission slips in drive


bro, i think your clutch is mess up. have it replace

Feb 28, 2009 | 1988 Honda Prelude

1 Answer

1992 honda prelude transmission wont go into gear


Sounds like the pressure plate! Try this, rev the engine for a sec then when it starts to slows down try to put it in reverse - if the gears grind, its the pressure plate which will come with the clutch kit for about 125-175.00.

:0)

*rack and pinion is steering not trans! Separate issue??


Jan 10, 2009 | 1998 Honda Prelude

Not finding what you are looking for?
1992 Honda Prelude Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...