The radio has a bulit in computer it also controls warning light ,door chimes and keys left in ign. and more. I changed radios and inatalled a new interface so all my chimes work correctly. no more problems.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
repairpal.com/brake-hydraulic-system-red-warning-light If the brake hydraulic system red warning light comes on and stays on, this indicates... and seems to come on and off depending on whether the vehicle is turning, ... if it is discovered that the light was illuminating due to a low brake fluid level.
well there are a few things this could be. first on most dash boards up toward the window is a little square. this is usually the sun sensor. if covered or dusty the sun won`t hit is and your lights remain on. if it is damaged it will need to be replaced. there are also ways of using your lights manually. They does this with a combo or things at the same time. like putting your key in the one position and turning your lights on manually while holding a door lock or some other combo. Try pulling your battery for about 20 minutes and put it back on PS MAKE SURE YOUR RADIO DOESN`T HAVE A SECURITY SYSTEM AND IF SO MAKE SURE YOU KNOW THE NUMBER OTHERWISE YOUR RADIO LOCKS.
This sounds like your alternator maybe going bad. When your alternator starts to go bad lights such as headlights, radio lights will go dim wipers will start to move slower but if you cut one of the things off such as the wipers the lights will get brighter for a few minutes then not long the car will shut completely down. Hope this helps.
Sounds like the HVAC control head needs to be recalibrated. The procedure is fairly easy, Heres how its done:
CALIBRATION/DIAGNOSTICS TEST ENTRY TO INITIATE TESTS: Set Blower motor ON HIGH Set Mode position to Panel Set Temperature to Cold (Both slide pots if equipped) Depress WASH and REAR WIPER button simultaneously for 5 Seconds (Until all LED's light) RESULTS: All LED's will turn on for 5 Seconds Calibration Test is running when REAR WIPER and INTERMITTENT are alternately flashing. Cooldown test is running if A/C and RECIRC are alternately flashing. Acceptable results is REAR WIPER LED is the only LED flashing. Push Rear Wiper to exit. After all tests have passed, Calibration Diagnostics and Cooldown can be run separately.
After that the lights should go out and everything should work properly as long as everything is in proper working order.