Question about 1994 Toyota MR2

1 Answer


Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Contributor
  • 36 Answers

You will have to raise the car and support it pon Jack stands and install it from underneath. MAKE SURE THAT you are turning the bolts in the correct direction to loosen the belt. My brother broke mine and I had to have AutoZone order one for me...(the long thin bolt attached to the alternator) After that you should be able to reach it by removing the underbonnet plastic and you may have to remove parts of your wheel well plastic to get a better view. Good Luck!

Posted on Feb 11, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Change wiring Harness On A 1996 Jeep grand Cherokee Laredo

With the petrol it is quite easy, just purchase a dictator system and get it fitted. Alternative is to fit a distributor and the coil system.

Oct 11, 2016 | Jeep Cars & Trucks

1 Answer

What year alternator will fit 2000 cavalier

The alternator for the 2.2 engine fits 1996 - 2002 models.

Aug 23, 2012 | 2000 Chevrolet Cavalier

2 Answers

Trying to find thermostat on a ford focus 1.4 zetec se 2003 but cant find it not where manual says

the thermostat is situated below and to the right of the alternator in the thermostat housing. if you romove the alternator you can then see the thermostat housing..hope this helps.

Apr 03, 2011 | 2000 Ford Focus

1 Answer


The diagram can be found here.
Remove the upper fan shroud and aircleaner assemblies for easy access.
To release tension on the belt turn the tensioner pulley nut clockwise and slip the belt off the alternator pulley. To refit the belt route as shown over every pulley except the alternator, once again release the tensioner and fit the belt to the alternator. See that the belt is properly seated over every pulley before restarting the engine.

Nov 11, 2010 | Isuzu VehiCROSS Cars & Trucks

1 Answer

How can I replace an alternator in a Toyta RAV4 2006?

if i recall correctly about a 30 - 40 minute job its mounted on top of the engine so easy to get to. theres just a couple of nuts and bolts to remove alternator along with wiring on the back of it. JUST REMEMBER TO DISCONNECT BATTERY EARTH LEAD FIRST then reconnect when new alternator fitted, ensure alternator drive belt is tensioned correctly also. hope this helps

Jul 17, 2010 | 1991 Toyota Corolla

1 Answer

How to remove and install a fan belt for Audi 1988 model 80?

loosen all the bolts on the alternator,swing it inward,toward the block,then fit belt,swing outward,with a lever to tighten belt,before tightening all bolts.(easy,but spanner rash......)

May 21, 2010 | 1988 Audi 80

1 Answer

How do I change the alternator belt in my 1999 Excel (list did not have the year)?

hi mate,your problem is fairly easy to fix-----remove the plastic under tray on the drivers side,from underneath, undo the main alternator bolt,just enough to move the alternator, now from the top undo the belt tension adjustment locking bolt,then back off the tension adjuster itself until the alternator belt is loose and can slip off the pulleys-----fitting your new belt is the reverse to this. all the best.

May 21, 2009 | 1994 Hyundai Excel

1 Answer

Fitting water pump

changing the waterpump is similer to changing a alternator...the only thing is that you have to take of the timing belt to take of the water pump

Jul 02, 2008 | 1999 Honda Civic

Not finding what you are looking for?
1994 Toyota MR2 Logo

Related Topics:

946 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides