The passenger side window stop working. so the regulator was replaced. now it seems if something is stopping the window and it makes a clicking noise from the regulator. i check for obvious things blocking and nothing. i did however find a 2" diameter white pulley laying inside.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
more than likely one of the switches are bad (down side of switch works but up side of switch dont) being as the switches are wired together if one goes bad other one won't work either take the switch out one of back doors should be same as front passenger door put rear switch in front passenger door if works then u know front door switch is bad if it doesn't then drivers door switch is bad u replaced window regulator Did that come with motor too??? if not check to see if motor is good there is two wires going to motor cut isolation back on wires and using some jumper wires attach one wire to positive terminal of a 12 volt battery attach other wire to negative terminal of battery window should move up or down reverse connections and window should move other way
some times the window regulators on toyotas need to be resett if they get jammed or they are interupted when operating ... an easy way to reset the regulator in toyotas is to disconnect the passenger regulator or switch wait 5 minutes the reconnect and using the passenger switch hold it up for 20 seconds and then down all the way holding it down when it stops for another 20 seconds. then check that the drivers side is now working and reset
the motor is getting weak. need to replace it and while your there check the regulator and the rubber seal that the glass slides in. they will get dirt in the groves and cause glass to stick. spray a lubricate in the rubber slots and try it .