Question about 2008 GMC Sierra 2500HD 2WD

1 Answer

Can't find Nav fuse

Got a Hyptech programme for my 08 GMC 2500 and need to pull it. thx

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 2 Answers

I have a 2008 GMC Sierra 2500HD Duramax and use the HyperTech software also. I assume you are talking about the installation instructions for HyperTech where it tells you to remove the ONStar and Radio fuse. Look in the owners manual for the fuse box layout under the hood. On mine, it's in the Duramax book and the only fuse that applies is the one listed for the Audio System. You will need to reset your clock when finished.

Posted on Feb 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset sat nav


pull fuse to nav
pull nav IOD. fuse

Jul 11, 2013 | Jeep Commander Cars & Trucks

1 Answer

Van won't start,rapid clicking heard when key is turned. need help/directions replacing starter relay for gmc vandura 2500, 1991


Check battery connections and battery fuse. Battery may not be large enough for the size of your van

Jan 18, 2013 | GMC Cars & Trucks

1 Answer

2001 GMC SIERRA 2500 HD alarm horn stopped working, reg horn dose'nt work either. Alarm lights still go off when activated through key fob. Checked all fuses and wiring, driving lights not working...


You need an ohm meter and check to see if ther is power at the horns and lights. There is no programming that turns off the horn on the steering column. But I have one of these trucks and had the same problem with the lights and horns but it didn't happen at the same time. My lightbulbs burnt out and the actual horns under the bumper did to. Hope this helps.

Jun 29, 2011 | GMC Sierra 2500HD Cars & Trucks

1 Answer

Have a 08 acadia with Nav. Problem started with


hi i don't know how many miles or time frame this is but this might be helpful
Updated Warranty and Goodwill Exchange Program for Electronic Products - (Feb 25, 2009)
like my car is a 01 grand prix the cat convertor was warranty 8 years they updated to 10 years
give the dealer a call
good luck


Nov 12, 2009 | 2006 GMC Acadia

1 Answer

Updating navagation map


There is an updated radio program from GM for this issue. Go to your dealer and have them look up and perform Bulletin #06-08-44-037. It is a software issue. Good Luck.

May 07, 2009 | 2007 GMC Yukon

1 Answer

2000 GMC 2500 Fuel Pump?


check for power too the pump first with a test light if you have power too it then the pump is bad if not youve got a short some gms also have a fuse check for that also

Feb 23, 2009 | 1985 Chevrolet Chevy

1 Answer

GMC Nav Map for Mexico


youll need a scanner from the dealer TECH 2 or equiv...

Dec 11, 2008 | 2008 GMC Sierra 2500HD 2WD

1 Answer

I have an '08 2500 w/ Duramax. My dash diagnostic LED said "change exhaust filter" then "se owners manual" and the engine light came on. There's no info for changing and exhaust filter...


The 08 diesel vehicles have a particulate filter much like a catalytic converter an a gas engine, these exhaust cannot be modified by removing the filter . The PCM will monitor this function and alert you with a service engine light if an issue is detected . Removing this filter will also cause the vehicle to go into a low power mode until the problem is repaired . It is also illegal to remove this filter as it part of your emission system for that vehicle . I don't think your programmer and intake would cause you any issues.

Aug 08, 2008 | 1993 GMC Sierra C2500

Not finding what you are looking for?
Cars & Trucks Logo

497 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...