1995 dodge ram 1500 V8

hi, you should find a serp. belt routing diagram on the cross member that supports your radiator. if not- disconnect neg batt terminal for safety. you'll need a long breaker bar metric. as most, if not all fasteners on your ram are in metric. cant remember right size socket, but just go through your metric set and "eyeball"it. once you have the proper socket-detention the belt by pulling breaker bar clockwise. remove old belt. it maybe useful to take a picture of how your old belt is routed with a camera equipped cell phone (if it is still on) so that if you get into trouble, you can look at the picture as a reference point. new serpentine belt install--insert new belt over the cooling fan route under crank pulley-over fan pulley, around p/s pump pulley,up and around a/c comp pulley, under idler pulley, over alternator pulley and finally around tensioner pulley. pull breaker bar clockwise to slip belt past and onto the tensioner pulley. release tension on tensioner. be sure to check tensioner indexing marks located on the tensioner arm this is to make sure the new belt is installed properly. reconnect neg batt cable to terminal-remove any hand tools from engine bay, start engine and observe belt operation. hope this helps!

its a 15 mm, go to the left pulley, and pull it towards the right, then pull the belt right off, as for putting it back on, go on crank, loop to left side of water pump, then go to the right and get the p/s pump pulley, then up to the a/c (if eqipped) then go over the idler pulley straight to the alternator, then put it on the tensioner., now you should just have the idler pulley open (smooth surface) and then once again move the tensioner to the right and slide it on the idler pulley.

sorry if that was confusing