Question about 1999 Dodge Stratus

1 Answer

Wont start car was runnjng and then it was just as if you cut the key off, it is only firing on 1 and 4 cyl

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

Coil pack is bad.

Posted on Jan 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My crank shaft is rotating twise the crank shaft. HOW MY 1342 FIRING WILL OCCURE?, I can spare only 30 digree for charge and spark plug contact. THERE ARE ONLY 2+2 CYLINDER. 180 DIGREE APPART KINDLY REPLY...


Your crankshaft turns 2x times the camshaft. Put it this way as # 1 cylinder reaches TDC (top dead center) of the firing/compression stroke, and this will be after a (8 degs BTDC) spark to ignite the air/fuel mix, the # 3 cyl. will be at BDC of the intake stroke and as #1 begins its power down stroke, (during explosion of air/fuel mix), #3 begins its compression up stroke, the #4 cyl. will be coming down with #1 cyl. but #4 will be in the beginning of its intake down stroke, and #2 cyl. will be coming up with #3 but #2will be in its BDC of the exhaust stroke. Which has just fired previously to #1. 1342134213421342 etc. Now the cam turns to open / close the valves; In the outline above, #1 cyl. valves will both be closed. #3 cyl. will have the intake starting to close at this point. #4 cyl. will just be starting to open its intake valve, and #2 will be starting to open its exhaust valve. Is all this clear as mud? So as the crank makes one full rotation (in a 4cyl. engine) only the firing of one cylinder has happened.and at every rotation one cyl. will fire. So #1 at TDC then one full rotation, #1 back at TDC, but this TDC is half of its 4 cycles, (1)Intake, (2)compression, (3)power, (4)exhaust. this 1234 refers to the 4 cycles of the rotation not firing order.

Oct 31, 2010 | 2008 Volkswagen Jetta

1 Answer

Have replaced several parts for my jeep and it still wont start what could it be have replaced battery plugs and wires and water pump it acts like its not getting gas but it has gas and the gas pump is...


First I would make sure that the lug wires on the distributor are correct. Sometime when replacing the wires is is easy to get them crossed. Below is the firing order on both engines for the Cherokee. I have also had the module go bad before as well. Below is a diagram which calls this module a camshaft positon sensor. Hope this helps. 800d646a.gif
cyl - 1 3 4 2 clockwise 6 cyl - 1 5 3 6 2 4 clockwise

Mar 28, 2010 | 1999 Jeep Cherokee

1 Answer

NUMBER 1 CYL WONT FIRE ITS GOT SPARK 2006 DODGE 5.7


Perhaps a bad or fouled injector? Pull the plug lead and see if you can detect gas in the chamber when you pull the plug. Good luck!

Mar 11, 2010 | 2005 Dodge Ram 1500

2 Answers

Spark plug wiring diagram for 98 tahoe car is missing need to know which wire goes were


You didn't post your engine size so please pick the applicable diagram:


37926a4.gif
1996-98 4.3L Engines Firing Order: 1-6-5-4-3-2Distributor Rotation: Clockwise


8c292b0.gif
1996-98 5.0L, 5.7L and 7.4L Engines Firing Order: 1-8-4-3-6-5-7-2Distributor Rotation: Clockwise



30ced3d.gif
4.3L Engines Firing order: 1-6-5-4-3-2 Distributor rotation: Clockwise


de67664.gif
4.8L, 5.3L and 6.0L Engines Firing order: 1-8-7-2-6-5-4-3 Distributorless ignition system (one coil on each cylinder)


bf80c63.gif
5.0L, 5.7L and 7.4L Engines Firing order: 1-8-4-3-6-5-7-2 Distributor rotation: Clockwise

Feb 14, 2010 | 1998 Chevrolet Tahoe

1 Answer

Lost ign key and remote


GO TO YOUR CHRYSLER/DODGE DEALER AND GIVE THEM YOUR VIN NUMBER AND THEY CAN CUT YOU ANOTHER KEY FOR YOUR VEHICLE.

Jan 24, 2009 | 2002 Dodge Stratus

1 Answer

Dead cylinders 2003 sebring


it sounds like you may have the wires on the wrong coil. It should be #1 on the #4 coil, and the #3 wire on the #2 coil. you probably have them backwards so 1 and 3 are firing on the exhaust stroke.
the firing order is 1-3-4-2.
they should be hooked like this.
82c8490.jpg

3ddfc56.jpg

Jan 23, 2009 | 2003 Chrysler Sebring

2 Answers

Daewoo lanos 2000 car is misfiring and wont run properly firing on cylinders 1 and 4 misfiring


have you changed the ignition wires? perhaps firing order crossed? if not coil pack or ignition wires faulty how do you know it is not "FIREING" on 1 & 4 have you tested it with a spark tester tool???

Dec 23, 2008 | 2000 Daewoo Lanos

2 Answers

Need to know firing order


6 cly firing order is 1-5-3-6-2-4
8 Cyl firing order is 1-8-4-3-6-5-7-2
4 cly firing order is 1-3-2-4

Oct 30, 2008 | 1986 Jeep Comanche

1 Answer

No Start. OBDii Code P2305.


i have the same problem could someone please help ? its getting cold outside and i live 30 miles from my job.

Aug 09, 2008 | 2004 Chrysler PT Cruiser

Not finding what you are looking for?
1999 Dodge Stratus Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...