Question about 1993 Toyota Camry V6

2 Answers

Car won't go in reverse

I back up and drove out of my driveway this morning, drove for 35 minutes to work and try to back in a parking spot. The car made a noise on the back right side and stop my car wont reverse. it will go forward. i am able to put it into gear but, when i accelerate to reverse it won't go. i have a 1993 toyota camry V4.

Posted by on

  • 1 more comment 
  • POKOA Sep 03, 2008

    but when i shorted out the computer it gave a reading of 6-2 and 6-3 which indicated that it was the number 1 and number 2 shift solinoid and when i took some voltage readings i had a low reading of only 8.2 volts should't it have at least 12 volts coming through to activate the solenoids properly

  • kvsrini Feb 09, 2009

    I have a toyota camry 1999 and it has the same problem.

  • naclark227 Feb 15, 2009

    93 toyota camry wont go in reverse. Even in netual you cant push the car. But if go fine in drive

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 321 Answers

If the vehcile is V6,then the trans model is the A540E,and if it is the 4 cylinder engine,the trans model is an A140E.Both are 4 speed overdrive transmissions,and sorry to report that on just abot every automatic trans on the road,reverse gear failure is almost always a mechanical problem inside the transmission because there are no shift solenoids involved with reverse as with forward gears.And you did say the forward gears were fine.Good luck.

Posted on Sep 01, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

It sound crazy but on Toyota's if one of the brake lights is out you can't get the car out of park. Change the bulb and see.

Posted on Mar 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 Buick Park Ave. won't start after pressing brake pedal.


sometimes the other switch is to cut out the cruise control when the brake is applied. I would more suspect something in the fuel injection controls such as a mass air flow sensor or throttle "switch." your car is probably too old to have an auxiliary air bypass valve but if it has one look at it as well. good luck

Sep 20, 2014 | 1992 Buick Park Avenue

2 Answers

Transmission


Try cleaning the idle speed control valve and the throttle body, then disconnect the battery negative and let stand for 5 minutes and try it.

Jan 22, 2014 | 2004 Chevrolet TrailBlazer

1 Answer

Won t start


run the fault codes and look for faulty cam/ crank position sensor as this is indicated by the backfire/hard start and lower idle RPM. Check that battery terminals are clean and tight..

Sep 22, 2013 | Pontiac Montana Cars & Trucks

1 Answer

Toyota camry drove home and parked and now won't move? NO ****** ISSUES BEFORE THIS!


It will not move in Reverse either? It could be

- the shift cable has broken
- the parking lock pawl has broken
- park/neutral position switch faulty
- transmission manual valve faulty

I think one of the first 3. There isn't much you can do except have it towed to a transmission shop.

Jan 16, 2013 | 1993 Toyota Camry

3 Answers

Alternator/Electrical??


check the connection on your battery terminal ends. if they are loose or corroded that could explain the intermittent no spark. also could be a short somewhere but id check the terminals first. I had that problem once and the car did all sorts of weird things. airbag light, check engine light, randomly wouldnt start until i would mess with the battery.

Nov 06, 2012 | 2000 Ford Explorer

Not finding what you are looking for?
1993 Toyota Camry V6 Logo

4,253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...