-
Dodge Master
17,989 Answers
- Posted on Jul 28, 2011
Re: I need the diagram for the drivebelt for a2002 Dodge...
Check this diagram and click over image for zoom...
Fig. Belt routing - 3.7L, 4.7L and 5.7L engines
-
Install new belt. Route the belt around all pulleys except the idler pulley.
-
Rotate the tensioner arm until it contacts its stop position.
-
Route the belt around the idler and slowly let the tensioner
rotate into the belt. Make sure the belt is seated onto all pulleys.
-
With the drive belt installed, inspect the belt wear indicator. On
4.7L Engines only, the gap between the tang and the housing stop
(measurement A) must not exceed 24 mm (.94 inches). If the measurement
exceeds this specification replace the serpentine accessory drive belt.
Hope helps.
×