Question about Cadillac DeVille

1 Answer

I need to rebuild my water pump (1960 deville 390 ci). How to I pull the old one apart

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,586 Answers

Usually you don't - many are not made to be rebuildable. You typically buy a new one and put it in.

Posted on Aug 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

98 caddy deville nothstar v8 how to replace heater coil have no heat and I'm loosing water somewhere


the heater core in a 1998 Cadillac is very tricky to replace.
start with getting a pressure test to determine where the exact location of the leak is, it may not be the heater core.
if you do decide to pull the dash apart to change the core make sure the battery is disconnected for at least an hour to allow the airbag system to discharge.

Oct 11, 2012 | 1998 Cadillac DeVille

1 Answer

Need a diagram showing exactly where the water pump is located on a 97 cadillac deville northstar


zjlimited_1587.jpg

Fig. Water pump assembly-4.6L Northstar engine (click image for zoom)



zjlimited_1588.jpg



Fig. Remove the water pump belt shield


zjlimited_1589.jpg


Fig. Remove the water pump adjuster pulley retaining bolt and


zjlimited_1590.jpg


Fig. Remove the water pump retaining bolts




Hope helps.


Jul 16, 2011 | 1997 Cadillac DeVille

1 Answer

Need the location of the PCV on a 62 Cadillac 390 ci. Thanks


PCV valve should be in the valve cover with a hose coming out of it. Pull it straight out, take it off of the hose, and shake it to see if the valve is loose, as it should be.

Oct 03, 2010 | Cadillac DeVille Cars & Trucks

2 Answers

Bottem end has a bad main bearing.....how much to rebuild entire motor?


this can range from $2800 on the low end with a short block and your old heads but you will put more money in it down the road. figure $4800 to do it right and do all the things that will make it last, new hoses, water pump, belts, Ing tune up, etc. .

Oct 01, 2010 | 1992 Cadillac DeVille

1 Answer

1960 cadillac 390 plug wire layout18436572 1357 driver side?


YES.Counter clockwise on the cap. 1 is at the rear of cap on the driver side of rear cap screw.
Points .016
Plugs .035
Timing 5 before
Fuel pump pressure 5 3/4 psi
325 HP
430 Torque@ 3100 rpm
4.000x3.875 Bore an stroke
10.50-1 compression
33 psi oil pressure
I hope this helps you and your Cadi.

Sep 27, 2009 | 1974 Cadillac Eldorado

2 Answers

Water pump still leaks 92 cadillac deville


yes always use gasket sealer on both sides of the gasket. and make sure the old gasket is completely removed but do not use a chisel ar anything as you will leave gouges in the metal and cause a leak. Best to clean it is with some sand paper and just take your time. And just a thougtht but all i use is the black gasket sealer. It seems to wwork the best.

Jul 28, 2009 | 1992 Cadillac DeVille

1 Answer

Land rover 1960 series 2


Well,if getting adequate fuel supply to the carb,then the problem is probably inside the carb now.Make certain a good flow of fuel to the carb,and if so,pull the carb off and recheck the floats drop and level height,also the needles and seats inside,and the gaskets for good condition.

Jul 25, 2008 | Land Rover Discovery Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...