What is the best way to remove a transmission out of a 2002 hyundia accent and reinstall i got the trans out with leaving the sub fram in the car but i cant get it back in the car should i have taken that off. thanks for your time
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
? 2:44
https://www.youtube.com/watch?v=fzqMNho3xIU
Nov 25, 2012 - Uploaded by mig dups
2000 Hyundai Accent GS turns over - no start. ... HyundaiCrankshaft Position Sensor Replace Timing Belt ...
saturns use a spin on transmission filter,similar to the motor oil filter.after-market filters like FRAM or PUROLATER are as good or better than dealer parts and likely less expensive.transmission fluid is drained from the plug in the pan,again,like the motor oil.
place the vehicle on a lift (preferred) and remove the RH front wheel. Remove the driver axel retaining nut (1 1/4" nut) and washer. Remove the lower ball joint retaining nut (17mm nut). Using a 10 oz hammer, strike the nuckle where the lower ball joint is attached to it (be careful not to strike the grease boot) while applying downward force on the lower control arm until it pops loose. Once loose, pry down on the lower control are while simultaneously moving the strut to one side untill the joint is clear/away from the knuckle. Now remove the drive axel from the the spline of the hub bearing. Using a pry bar, pop loose the axel from the transmission differential. Installation of the new axel is in reverse order.
×