Question about 1990 Nissan Pulsar
i just bought nissan pulsar lx 2000, it suddenly wont start, i am assuming its the anti-theft system,
i couldnt find any button saying anti theft in my remote, sorry im still new with this car, could please give me info about how to activate or deactivate this anti-theft system. Thanks a lot
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: fuel filter location on a
your car's fuel filter is located inside the gas tank near the floater.remove the back seat. you can see the fuel pump wires.remove the screws.pull it then you can see the fuel filter.
Posted on Aug 12, 2008
SOURCE: nissan pulsar wont start
Replace the sparks plugs, if the car is failing on one cylinder it will be hard to start.
Check the air intake and the air filter, if air filter is dirty replaced, only to test the car try starting with intake open and no air filter, if it starts it is an air intake problem.
Check the fuel filter and check that fuel have pressure, if fuel has no pressure it is either a faulty pump or an obstructed pipe.
Common cause for car not starting is distribution, with distribution rotor you often have to replace distributor cap or coil.
If it is electronic distribution you have to scan distribution module.
If you have an anti theft system, this can also cause the car not to start, usually you unlock anti theft with car key.
If it is none of the above, it can be a car computer problem, the car computer module (ECU) can be scanned using a code reader at any good garage, in this case the mechanic will get error codes from car ECU and be able to troubleshoot further the problem.
Posted on Aug 28, 2008
If it is a 2003 model year vehicle follow this procedure. If it doesn't work, you may have the wrong fob which happens all the time.
Sit in vehicle and close all doors.
COMPLETELY insert and remove ignition key more than six times within 10 seconds.
Hazard lights should flash twice.
Turn ignition to ACC position
Press and hold any button on the new key fob hazard lights will flash twice
For a second key fob using the master lock switch, lock and unlock the doors then hold down any button on the second remote until the hazard lamps flash twice.
Then you are done open the door to exit the programming mode.
If the lamps didn't flash when holding down the key fob make sure you have the right key fob, they are different for each car.
Posted on Nov 26, 2008
Tips for a great answer:
Mar 26, 2016 | Nissan Cars & Trucks
Jul 09, 2017 | Nissan Cars & Trucks
Jan 13, 2012 | 1990 Nissan Pulsar
Jun 23, 2010 | Cars & Trucks
Dec 19, 2009 | 1989 Nissan Pulsar
Apr 06, 2009 | 1988 Nissan Pulsar
Aug 28, 2008 | 1990 Nissan Pulsar
Jul 04, 2014 | 1990 Nissan Pulsar
Apr 06, 2017 | 1990 Nissan Pulsar
125 people viewed this question
Usually answered in minutes!