How to replace rear wiper motor on 2007 chevy uplander

http://www.youtube.com/watch?v=kXP7s-gCOkg

Your motor is more then likely locked up. Replace the wiper motor. First check the relays.

1. Remove the rear wiper arm 2. Remove the wiper driveshaft nut( nut behind wiper arm) and the washer and seal from the driveshaft 3. Remove liftgate trim pannel 4. Dissconect electrical conn and retaining screws from the motor. Reverse to install. But my advice is put the motor in but leave arm off, run the wiper motor to make sure it is working and to make sure it is at its resting spot. Then put the arm back on.

REAR WIPER MOTOR IS STARTING TO SEIZE UP. IT WILL MOVE FOR NOW BUT IT IS GOING TO STOP SOON. YOU WILL NEED TO REPLACE MOTOR

check the wireing with a test light if that dosent tell you any thing you might need to replace motor or see if its connected to the motor

Get a fine needle and try unblocking the jets in the outlet nozzle first

i have a 2006 chevy uplander and i need to change the low beam headlamp how do i do it, also about a month after we had got the van the rear wiper stopped working i haven't checked the fuse yet, but is this a common problem for the uplander, and also the abs light stays on what should i do for that problem, and also when we drive it and then shut it off it does not want to turn on right away.

I have a 2007 Chevolet Uplander and the rear wiper had failed. Is there any type of recalls on this part as you can find the part in any dealership

The rear wiper on the uplander is a common BOSCH unit and is very prone to one very small but very easy ( and CHEAP to fix ) problem. The shaft that goes through the glass on the rear hatch needs to have new grease.Thats it......If you think you need a new wiper motor try this.......take off your old wiper motor and remove the star drive screws that hold this thing together.Now pull this thing appart. Dont be afaid to do this remember you think that you are going to buy a new one anyway right. Inside you will see the electric motor with a worm gear thar turns a big yellow(or white) plastic wheel.sitting on top of that is a funky metal linkage that is connected to the BOTTOM of the shaft.On the TOP end of the shaft you will need to remove the small plastic ring and under that the small rubber o-ring. Now you need to pull the shaft and the linkage out of the unit. They should just pull out with no effort BUT you will find that they are stuck because all the grease has gone hard around the shaft stopping it from moving.Use a little penitrating oil around the shaft and work at it and it will come out. Now use a little break cleaner to clean the shaft and linkage ,apply new grease and put the thing back together again. PROBLEM SOLVED......try it .....trust me you dont need a new motor :-) If you really want to be lazy you dont even have to take the car apart just unbolt the rear wiper arm and remove thearm fron the car then clean the end of the shaft andunder all that dirt you will see the small plastic ring and under that the small o-ring .....remove both of these.now spray some penitrating oil down the shaft.give it a little timeand spray some more.try the rear wiper,if your lucky it will start to turn.put it all back together again.

The Fuse is loacated in the instrument fuse panel fuse #3 located on the passenger side of the dash, there is round handle to pull the cover off