Question about 2002 Oldsmobile Bravada

1 Answer

2002 oldmobile bravada ignition key is stuck in lock position

Help... my ignition key is stuck in the lock position because I pushed the button under the ignition key to put it in the lock position because my car wouldnt go into lock. but now that i have it in the lock position it wont turn

Posted by on

  • 2 more comments 
  • user376950 Mar 02, 2009

    My key won't turn at all

  • Anonymous Mar 13, 2014

    the shift is stuck and the car wont start and the key wont turn to off position

  • Anonymous Mar 18, 2014

    I have tried both of my keys but my ignition is stuck on lock

  • Anonymous Mar 21, 2014

    won't turn to lock position. does not start car or any electronics.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,263 Answers

Try and turn your steering wheel a little bit left or right and and the same time try and turn the key when it turns toward the dash then try and turn the key back. try and repeat this several times if neccessary. this should work. please rate this solution. thanks

Posted on Aug 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

If a starter was to go out on a 2002 Oldsmobile bravado would it make the key stay stuck in the ignition.was told to replace the starter I have a starter from a 1999 olds 88 ls could I use it on it


I don't know where you heard that , no a bad starter would not make the key stay stuck in the ignition lock cylinder !!!!!!! Can you put the trans gear selector in park ? or is it in a gear position ?

Apr 03, 2015 | 2002 Oldsmobile Bravada

1 Answer

Key wont turn stuck in off position?


I just did one of those last week, it was the ignition tumbler that was bad

Jan 28, 2015 | 2002 Oldsmobile Bravada

1 Answer

My 1998 Olds Bravada has the key stuck in the ignition. I paid to have a new ignition key cylinder put in, but the new one does the same thing. The key will start the car etc. but won't come out of...


I know in the newer versions of the Bravada, Trailblazers, Envoys, the ignition switch itself is always the culprit. Not the switch the key goes in, but it's located under the steering wheel column. I know how to replace the newer ones but not yours. That's the first place I'd look.

Jun 07, 2011 | 1998 Oldsmobile Bravada

1 Answer

1991 oldmobile bravada. Key is locked in ignition switch. Engine is running and can't move the gear shift. ABS light is on


Pull fuses till engine shuts off then disconnect battery for now till you or someone can run test.

Jan 07, 2011 | 1991 Oldsmobile Bravada

2 Answers

Key stuck in 2009 chevy hhr ignition help please


You may want to try pushing fordward harder into the park position while turning the key to the off position. The locking cable may need adjustment. If this does not work, try turning the collar just behind the keyswitch counter clockwise while trying to remove the key.Thanks, Dana

Mar 29, 2010 | 1999 Honda Accord

1 Answer

Car was stolen broke the ignition


REMOVAL

  1. On models equipped with airbag, disarm airbag as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
  2. On all models, disconnect battery ground cable.
  3. Remove ignition switch as described under STARTING AND CHARGING SYSTEMS/COMPONENT REPLACEMENT AND REPAIR PROCEDURES/IGNITION SWITCH.
  4. Remove key light case from lock body, if equipped.
  5. On 1989 Accord models, place ignition lock cylinder in the ACC position.
  6. On except 1989 Accord, place ignition lock in the I position.
  7. On all models, position suitable punch into hole on lock cylinder housing and depress pin, then remove lock cylinder from housing.
INSTALLATION

  1. On 1989 Accord models, install ignition lock cylinder as follows:
    1. Place ignition lock cylinder in the LOCK position.
    2. Rotate key until it is almost at the ACC position, then insert lock cylinder until pin contacts housing.
    3. Rotate key to ACC position, then push pin in and insert lock cylinder into housing until pin clicks into place.
  1. On except 1989 Accord, install ignition lock cylinder as follows:
    1. Place ignition lock cylinder in the O position.
    2. Rotate key until it is almost at the I position, then insert lock cylinder until pin contacts housing.
    3. Rotate key to I position, then push pin in and insert lock cylinder into housing until pin clicks into place.
  1. Install ignition switch and connect battery ground cable.
SRS wire harness is routed near the ignition switch.

CAUTION:
  • All SRS electrical wiring harnesses are covered with yellow outer insulation.
  • Before disconnecting the SRS wire harness, install the short connector on the airbag.
  • Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.
IGNITION SWITCH
  1. Remove the steering wheel, then remove the steering column covers.
  2. Disconnect the 7-P connector from the under-dash fuse box.
  3. Insert the key and turn it to "0."
  4. Remove the 2 screws and replace the base of the switch.

Feb 13, 2009 | 1992 Honda Accord

1 Answer

After replacing the gear shift cable on my Oldsmobile Bravada the key will not come all the way back to the lock position and the battery light stays on.


im not sure what linkage you replaced cause it is electronic. if key is stuck in acc. posision the problem is the ignition switch. the reason i say this is cause when you turn the key it elec. releases the shifter and when the switch gos bad it does not. a new ignition switch should be purchaced from a gm dealer.until fixed you will have to disconnect batt. every time until fixed and i would also use the park brake when not driving.

Jan 09, 2009 | 2002 Oldsmobile Bravada

2 Answers

Key stuck in ignition of 2002 chev. trailblazer


Remove the cover of the switch, there is a silver button below the place where you put the key. Press it and the key will be released!

Dec 21, 2008 | 2002 Chevrolet TrailBlazer

3 Answers

Key stuck in ignition


Under the steering column is an access plug. Remove the plug and insert a small shaft driver into the hole and push up gently, the key will release.

Oct 17, 2008 | 1997 Oldsmobile Bravada

Not finding what you are looking for?
2002 Oldsmobile Bravada Logo

905 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...