Question about 1993 Dodge Caravan

1 Answer

93 grand caravan se 3.3 liter

My van will not change gears when driving ,got new input and output sensors to put in but van is overheating, checked fan motor and it works i changed thermostste but it keeps overheating i dont know where fan relay is i have 5 relays but i dont know which one it is can u help me? thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 743 Answers

It is usually the third one from back to the front.

Posted on Sep 30, 2008

  • Lyle D. Rowh Sep 30, 2008

    In addition, you can take the relay apart if you are careful and clean the contact points with a peice of sand paper, but before doing that see if the fan blade will turn freely. You also, can take a jumper wire and apply 12 volts to the voltage side of the fan to see if it will work. If it does work than go after the relay. You can take a back of a screwdriver handle and tape that relay and sometime it will make, but the van will need to be hot enough to request the relay on. Hope that helps.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my van stall in reverse, drive and when i push it in netural?


try replacing your air filter not enough air will cos it to die i had that problem it would start and go in eny gear but as soon as i tapped the gas it would stall out

Nov 25, 2012 | 1991 Dodge Grand Caravan

1 Answer

Only code p0734 2001 caravan


Hi there:
This code means that the transmission is slipping in high gear and the TCM (TRansmission Control Mocule) logic thinks it has incorrect ratio since it monitors input and output speed. Keep in mind that TCM uses input from the input speed sensor and output speed sensor to determine gear ratios. The TCM then compares the known gear ratio to the calculated gear ratio for the current range.


Check HERE test procedure.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.


Thank you for using FixYa, have a nice day.

Aug 24, 2012 | 1997 Dodge Caravan

1 Answer

How big should the hole be for the speed sensor in the transmisson for my 1997 dodge grand caravan se 3.0 liter


There is an input and output speed sensor. They look identical. The input is just user the cooler hoses and the output is to the right as your standing in front of the ven. A one inch socket will work to remove them. The hole in the transmission will be slightly smaller than one inch. If you need an exact size you can remove one of them nod measure it.

Jul 16, 2011 | 1997 Dodge Grand Caravan

1 Answer

Drive a 99 plymouth grand voyager expresso 3.3l flex fuel here is the problem. it has a rebuilt tranny that's less than 9mos old had the van one month drove fine now the first 20 minutes the...


The output shaft sensor is where the TCM gets its info. And what the speedometer runs off of. It is best to have a diagnostic ran on this first. But shooting from the hip, I would go for the output sensor.

Jul 03, 2011 | Plymouth Voyager Cars & Trucks

1 Answer

Would like to know what the process is to reset the TCM on a 2002 dodge grand caravan, the van while driving it stays stuck in 2nd gear was told that the TCM needs to be rest i need th precdure how to rest...


if its stay in second speed the computer put the tramission in limp mode because there a problem in the trasmission you need to get your van pass on a scanner to see the code it could simply be the input or output sensor there sensor on the transmission and to reset that simply disconnect the battery for 2 minute after you see your trams will change all speed let me no and thanks for using fixya

Mar 01, 2011 | 2002 Dodge Grand Caravan

2 Answers

I have a 1994 dodge grand caravan with a 3.8 v6 the transmission get stuck in second gear after driving for 30 min was told it could be a speed sensor


The speed sensor could indeed be preventing the van from switching gears. Have this checked into or you could do it yourself by reading this article and following the link it provides for testing. http://www.engine-light-help.com/speed-sensor.html

Hope this helps:)

Jan 24, 2011 | 1994 Dodge Grand Caravan

1 Answer

Can you tell me if a 97 dodge caravan transmission 3.3 will interchange with a 3.8. This is the trouble i have had and have decided to put in Transmission. Driving down the road and van sounded like it...


1. Yes the 3.3 and the 3.8 are the same bolt pattern. But the gear ratio in the differential might be different.

2. Did you replace the filter and put it back together? Does it do the same thing after you changed the filter? If it was an electrical issue with speed sensors or the solenoid pack, reverse would still work.

Jun 09, 2010 | 1997 Dodge Caravan

2 Answers

2002 DODGE GRAND CARAVAN SPEED JUMPS AND RPM REV UP ON STARTUP


Assuming you meant tachometer, not speedometer, then it's the throttle position sensor. I just replaced mine on a 2003 Jeep Cherokee, and they are prone to failure on all Chrysler products, especially if over 70k-80k miles.

Dec 16, 2009 | 2002 Dodge Grand Caravan

4 Answers

1996 dodge grand caravan transmission will not shift out of 1st gear, speedometer doesn't work either


Mounted on the trany is a speedometer sensor. The vehical will not up-shift it, sensor, is malfunctioning. The vehicles computer doesn't know that it is not going fast enough to change gears.

Dec 08, 2009 | 1996 Dodge Caravan

3 Answers

Tranmission problem on 1999 Dodge Grand Caravan


When the trans. sticks itself in 2nd gear and stays there is because it's detecting a trans. problem and puts itself in "limp in" mode. When it happens again, to somewhere to have a scan done on the trans. so you can find out which sensor on the trans. is acting up.

Jun 22, 2008 | 1999 Dodge Grand Caravan

Not finding what you are looking for?
1993 Dodge Caravan Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...