Question about Hyundai Motor 2003 Elantra

1 Answer

How do I clean throttle body on 2003 Hyundai Elantra GLS?

What steps do I take on how to clean throttle body?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 53 Answers

What u do is go to your local auto supply store and buy throttlebody cleaner you remove the rubber hose from the throttle body with the engine off of course u open the throttle and spray cleaner in it then use a tooth brush inside it replace the hose done
except it will be hard to start the first time crank engine over with foot to the floor on the gas pedal do not pump it

Posted on Oct 19, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is a/c drain hose on 2003 hyundai elantra gls


Look for a hose coming out of your firewall running down to the bottom of the car

Oct 17, 2016 | 2003 Hyundai Elantra GLS

1 Answer

I have an Elantra 1.6 gls rough idling when switching on ac 1.6gls 2003


First try cleaning the engine throttle body and the idle speed control valve, it may have a slow idle due to these parts being full of sludge. Use a can of spray throttle valve cleaner. After cleaning disconnect the battery negative post for 5 minutes and then drive it about 5 miles, if the idle shake continues the next step is to install new engine and transmission mounts,.

Jun 26, 2016 | AC Cars & Trucks

1 Answer

Is it necessary to have the water to circulate through the throttle of my fuel intake of my elantra 2001 Hyundai


Not essential, but you may find engine will idle fast, most throttle bodies with coolant flowing through them have a thermostat inside to raise idle when engine coolant temperature is low...

Blocking off heater won't harm anything, just run hose to bypass heater core...

Feb 11, 2016 | 2001 Hyundai Elantra GLS

1 Answer

Where is the air charge temp sensor located on a 2003 hyundai elantra


WHERE IS AIR CHARGE TEMP. SENSOR LOCATED ON A 2003 HYUNDAI ELANTRA

Nov 07, 2012 | 2003 Hyundai Elantra GLS

1 Answer

Hyundai Elantra GLS 2003 starter does not work


it can if you have the proper tools and a little patience its not very hard at all it may be a little snug i cant remember off hand where the starter is located on that car but its relatively an easy fix.

May 21, 2010 | Hyundai Motor 2003 Elantra

2 Answers

2003 Hyundai Elantra GLS. Check engine light, code PO133


Did you use a aftermarket O2 sensor or a genuine Hyundai one? If it's an aftermarket one it may be bad or not as good as the OEM one. See here for more details and other potential causes: P0133

Feb 10, 2010 | Hyundai Motor 2003 Elantra

2 Answers

2003 hyundai elantra gls abs/tcs light on


Two seperate problems. I would say you have a bad wheel sensor. A trip to a local big chain parts store will tell you. They will run a diagnostic and pull the code for free. Hope this helps...

Sep 07, 2009 | Hyundai Motor 2003 Elantra

1 Answer

Rear hub nut on a2003 hyundai elantra


Very wild guess. I replaced the bearings in my 2003, and was looking in my tool box. I came across a 1 1/4" socket that I purchased around the same time, but I realize that it should be the metric equivalent of this, so it probably did not fit perfectly. Metric conversion would be 31.75 mm.

Oct 11, 2008 | Hyundai Motor 2003 Elantra

Not finding what you are looking for?
Hyundai Motor 2003 Elantra Logo

Related Topics:

554 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...